473949
15
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
15
GENERATING SET USE
Avoid overloading the generating set; the following rules must be respected if the
generating set is to perform properly:
- the sum of the power outputs of the machines connected simultaneously to the
generating set must be compatible with the characteristics given in the last pages
of this manual,
- some appliances draw more power when starting up than their nominal power
rating (electric motors and compressors are examples). We recommend that you
contact a Honda dealer in case of doubt,
- do not exceed the maximum current specified for each receptacle.
The generating set must not be loaded to its nominal power if conditions are such
that the normal cooling requirements are not met (atmospheric pressure: 100 kPa [1
bar]). When using the generating set in unfavourable conditions, take care to reduce
the power load. Example: 28 A (limited to X A by the circuit breaker).
INFORMATION ON THE CONSTRUCTION OF THE GENERATING SET
The generator windings are not connected to the earth; the system is thus safe by
construction and limits the risks of electrocution. It is strictly forbidden to connect the coils
to the generator earth, except when using a 30 mA differential circuit breaker for the
protection of persons. The installation of such a device must be carried out by a specialist
electrician and requires all appliances to be earthed.
The differential circuit breaker acts as a check against faulty insulation. It cuts off the power
when there is a detectable fault in the insulation between a voltage-bearing conductor and
any part of the earth, on the output side of the differential circuit breaker.
ECT6500 (230/400V)
The three 230 V single-phase receptacles are connected in parallel to the terminals of a
winding specially reinforced to withstand a current of 20 A. The single-phase 230 V power
output given on the rating plate, and also indicated in the table of characteristics, is
available only on these receptacles and when no other three-phase load is connected to
the generator’s outputs. Never connect the generator’s three-phase receptacle to a single-
phase splitter box.
When using simultaneously 230 V single-phase and 400 V three-phase current, the current
intensity per phase must not exceed 10 A.
Ex: Power available from receptacles for simultaneous three-phase and single-phase use.
Three-phase 0 3000 W 4000 W 5000 W 6000 W 7000 W
Single-phase 4500 W 1300 W 950 W 650 W 300 W 0
OMec_GB.book Page 15 Vendredi, 21. octobre 2005 3:05 15
15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

honda-ec4000

Suche zurücksetzen

  • Hallo. Wollte nur kurz nachfragen ob das Gerät EC4000K2 als Notstromaggregat zur Versorgung eines Einfamilienhauses geeignet ist. ( ? Inclusive Elektronische Geräte / TV, Kühl-und Gefriergetäte etc.) Mit freundlichen Grüßen Eingereicht am 8-6-2022 10:57

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honda EC4000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Honda EC4000

Honda EC4000 Bedienungsanleitung - Deutsch - 24 seiten

Honda EC4000 Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info