Bedienungsanleitung Honda GS 160 (Seite 6 von 40) (Englisch, Französisch, Spanisch)

527024

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

ENGLISH

SERVICING YOUR ENGINE

THE IMPORTANCE OF MAINTENANCE

Good maintenance is essential for safe, economical, and trouble-free

operation. It will also help reduce pollution.

To help you properly care for your engine, the following pages include

a maintenance schedule, routine inspection procedures, and simple

maintenance procedures using basic hand tools. Other service tasks

that are more difficult, or require special tools, are best handled by

professionals and are normally performed by a Honda technician or

other qualified mechanic.

The maintenance schedule applies to normal operating conditions. If

you operate your engine under severe conditions, such as sustained

high-load or high-temperature operation, or use in unusually wet or

dusty conditions, consult your servicing dealer for recommendations

applicable to your individual needs and use.

Remember that an authorized Honda servicing dealer knows your

engine best and is fully equipped to maintain and repair it.

To ensure the best quality and reliability, use only new Honda

Genuine parts or their equivalents for repair and replacement.

Maintenance, replacement, or repair of the emission control

devices and systems may be performed by any engine repair

establishment or individual, using parts that are “certified” to

EPA standards.

MAINTENANCE SAFETY

Some of the most important safety precautions follow. However, we

cannot warn you of every conceivable hazard that can arise in

performing maintenance. Only you can decide whether or not you

should perform a given task.

SAFETY PRECAUTIONS

• Make sure the engine is off before you begin any maintenance or

repairs. This will eliminate several potential hazards:

– Carbon monoxide poisoning from engine exhaust.

Be sure there is adequate ventilation whenever you operate

the engine.

– Burns from hot parts.

Let the engine and exhaust system cool before touching.

– Injury from moving parts.

Do not run the engine unless instructed to do so.

• Read the instructions before you begin, and make sure you have

the tools and skills required.

• To reduce the possibility of fire or explosion, be careful when

working around gasoline. Use only a nonflammable solvent, not

gasoline, to clean parts. Keep cigarettes, sparks, and flames away

from all fuel related parts.

MAINTENANCE SCHEDULE

Perform at every indicated month/year or operating hour interval,

whichever comes first.

(1)

(1) For commercial use, log hours of operation to determine proper

maintenance intervals.

(2) Service more frequently when used in dusty areas.

(3) Change engine oil every 25 hours when used under heavy load or in high

ambient temperatures.

(4) These items should be serviced by an authorized Honda servicing dealer,

unless you have the proper tools and are mechanically proficient. Refer

to the Honda shop manual for service procedures. See “Honda

PUBLICATIONS” on

page 11 for ordering information.

Failure to follow this maintenance schedule could result in

non-warrantable failures.

REFUELING

This engine is certified to operate on unleaded gasoline with a pump

octane rating of 86 or higher.

We recommend refueling after each use to minimize the air present in

the fuel tank.

Refuel in a well-ventilated area with the engine stopped. If the engine

has been running, allow it to cool first. Never refuel the engine inside

a building where gasoline fumes may reach flames or sparks.

You may use regular unleaded gasoline containing no more than 10%

ethanol (E10) or 5% methanol by volume. In addition, methanol must

contain cosolvents and corrosion inhibitors. Use of fuels with content

of ethanol or methanol greater than shown above may cause starting

and/or performance problems. It may also damage metal, rubber, and

plastic parts of the fuel system. In addition, ethanol is hygroscopic,

which means it attracts and retains water in the fuel system. Engine

damage or performance problems that result from using a fuel with

percentages of ethanol or methanol greater than shown above are not

covered by warranty.

If your equipment will be used on an infrequent or intermittent basis

(more than 4 weeks between usage), refer to the Fuel section of the

STORAGE chapter (page 8) for additional information regarding fuel

deterioration.

 WARNING

Improper maintenance, or failure to correct a problem before

operation, can cause a malfunction in which you can be

seriously hurt or killed.

Always follow the inspection and maintenance

recommendations and schedules in this Owner’s Manual.

 WARNING

Failure to properly follow maintenance instructions and

precautions can cause you to be seriously hurt or killed.

Always follow the procedures and precautions in this Owner’s

Manual.

Regular

Service Period

Item Page

Before each

use

Check: Engine oil level

Check: Air filter

page 7

First month

or 5 hours

Change: Engine oil page 7

Every 3 months

or 25 hours

Clean: Air filter

(2)

page 7

Every 6 months

or 50 hours

Change: Engine oil

(3)

Clean: Air filter

(2)

page 7

Every year

or 100 hours

6 month items above plus:

Check-adjust: Spark plug

Clean: Spark arrester (if equipped)

Check-adjust: Idle speed

(4)

Clean: Fuel tank and filter

(4)

Check-adjust: Valve clearance

(4)

page 8

Every 2 years

or 200 hours

Yearly items above plus:

Replace: Air filter

Replace: Spark plug

page 7

page 8

Every 2 years Check: Fuel lines

(4)

(replace if

necessary)

Honda GS 160 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda GS 160

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info