Bedienungsanleitung Honda GXV630 (Seite 15 von 57) (Englisch, Französisch, Spanisch)

566434

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

ENGLISH

Emission Control System Information

Source of Emissions

Replacement Parts

Maintenance

Problems That May Affect Emissions

Tampering and Altering

The U.S., California Clean Air Act, and Environment Canada

The combustion process produces carbon monoxide, oxides of

nitrogen, and hydrocarbons. Control of hydrocarbons and oxides

of nitrogen is very important because, under certain conditions,

they react to form photochemical smog when subjected to

sunlight. Carbon monoxide does not react in the same way, but it

is toxic.

The emission control systems on your Honda engine were

designed, built, and certified to conform with EPA, California

(models certified for sale in California), and Canadian emission

regulations. We recommend the use of Honda Genuine parts

whenever you have maintenance done. These original-design

replacement parts are manufactured to the same standards as the

original parts, so you can be confident of their performance. The

use of replacement parts that are not of the original design and

quality may impair the effectiveness of your emission control

system.

A manufacturer of an aftermarket part assumes the responsibility

that the part will not adversely affect emission performance. The

manufacturer or rebuilder of the part must certify that use of the

part will not result in a failure of the engine to comply with

emission regulations.

Follow the maintenance schedule on page . Remember that this

schedule is based on the assumption that your machine will be

used for its designed purpose. Sustained high-load or high-

temperature operation, or use in unusually wet or dusty conditions,

will require more frequent service.

Honda utilizes appropriate air/fuel ratios and other emissions

control systems to reduce the emissions of carbon monoxide,

oxides of nitrogen, and hydrocarbons.

Additionally, Honda fuel systems utilize components and control

technologies to reduce evaporative emissions.

Black exhaust smoke or high fuel consumption.

Afterburning (backfiring).

Misfiring or backfiring under load.

Rough idle.

Hard starting or stalling after starting.

If you are aware of any of the following symptoms, have your

engine inspected and repaired by your servicing dealer.

Altering or defeating the governor linkage or speed-adjusting

mechanism to cause the engine to operate outside its design

parameters.

Removal or alteration of any part of the intake, fuel, or exhaust

systems.

Tampering with or altering the emission control system may

increase emissions beyond the legal limit. Among those acts that

constitute tampering are:

The following instructions and procedures must be followed in

order to keep the emissions from your Honda engine within the

emission standards.

EPA, California, and Canadian regulations require all

manufacturers to furnish written instructions describing the

operation and maintenance of emission control systems. 6

09/07/17 20:11:50 32Z6M600_015

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda GXV630 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda GXV630

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info