3.4 CONNECTING THE BATTERY
The battery (1) is situated under the seat
and is held in place by a spring (2).
Connect the two red cables (3) to the
positive terminal (+) and the three black
cables (4) to the negative terminal (–)
using the supplied screws and following
the illustrated sequence.
Always fully charge
the battery according to the instructions
in the battery’s manual (
☛
6.2.5).
To prevent the safety device in the electronics card from cut-
ting in, never start the engine until the battery is fully charged!
Follow the battery manufacturer's instructions regarding
safe handling and disposal.
3.5 FITTING THE GRASS-CATCHER BRACKETS
Fit the two supports (1) and (2) on the rear plate, using the supplied screws (3),
washers (4) and nuts (5), exactly following the sequence shown.
Position the screws in the centre of the slots (6) without fully tightening.
Hook on the grass-catcher to the supports, checking that there is an even spa-
cing of 6 to 8 mm between the two plastic
covers.
This makes it possible for the grass-cat-
cher to rotate properly when being emp-
tied, but still prevents grass cuttings from
escaping.
To get the correct spacing, adjust the
position of the fastenings or the supports
in relation to the slots (6), then fully tigh-
ten the screws (3).
!
WARNING!
IMPORTANT
IMPORTANT
EN 11UNPACKING AND ASSEMBLY
