Sharpen the two cutting edges using a
medium grade grinding wheel and check
the balance by holding the blade up with a
round 18 mm Ø bar inserted in the central
hole.
Damaged or bent
blades must always be replaced;
never try to repair them! ALWAYS USE
MANUFACTURER'S GENUINE
REPLACEMENT BLADES BEARING
THE SYMBOL !
The blades differ, are at 90° to one another, and are con-
tra-rotating. When installing them, make sure that they are correctly posi-
tioned by refering to the code number marked on the outside of each one.
When re-fitting the blades, always follow
the indicated sequence, making
sure that the blades' wings are
facing towards the interior of the
cutting deck and that the cupped
side of the cup washer (1) is
pressing against the blade. Fully
tighten the fixing screws (2),
preferably using a torque wrench
set at 45-50 Nm. If the shaft hub
(3) came off when dismantling the
blade, make sure that the key (4)
is firmly in its correct position.
6.3.2 C
UTTING DECK ALIGNMENT
The cutting deck should be properly set to obtain a good cut.
For achieving good results from cutting, the front part should
always be 5 - 6 mm lower than the rear.
– Put the machine onto a flat surface and check the tyre pressures;
NOTE
!
WARNING!
!
WARNING!
!
WARNING!
EN 44 MAINTENANCE
