Bedienungsanleitung Honda Honda Engines GX120 Regular (Seite 9 von 43) (Englisch)

13099

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

HELPFUL TIPS & SUGGESTIONS

STORING YOUR ENGINE

Storage Preparation

Cleaning

Fuel

Adding a Gasoline Stabilizer to Extend Fuel Storage Life

Inspection

AIR VENT TUBE

IDLE SPEED

Adjustment

ENGLISH

RETAINERS

AIR VENT TUBE

THROTTLE STOP SCREW

Proper storage preparation is essential for keeping your engine

trouble-free and looking good. The following steps will help to

keep rust and corrosion from impairing your engine’s function and

appearance, and will make the engine easier to start when you use

it again.

If the engine has been running, allow it to cool for at least half an

hour before cleaning. Clean all exterior surfaces, touch up any

damaged paint, and coat other areas that may rust with a light film

of oil.

Using a garden hose or pressure washing equipment can force

water into the air cleaner or muffler opening. Water in the air

cleaner will soak the air filter, and water that passes through the

air filter or muffler can enter the cylinder, causing damage.

Gasoline will oxidize and deteriorate in storage. Deteriorated

gasoline will cause hard starting, and it leaves gum deposits that

clog the fuel system. If the gasoline in your engine deteriorates

during storage, you may need to have the carburetor, and other

fuel system components, serviced or replaced.

The length of time that gasoline can be left in your fuel tank and

carburetor without causing functional problems will vary with

such factors as gasoline blend, your storage temperatures, and

whether the fuel tank is partially or completely filled. The air in a

partially filled fuel tank promotes fuel deterioration. Very warm

storage temperatures accelerate fuel deterioration. Fuel problems

may occur within a few months, or even less if the gasoline was

not fresh when you filled the fuel tank.

Fuel system damage or engine performance problems resulting

from neglected storage preparation are not covered under the

Distributor’s Limited Warranty

You can extend fuel storage life by adding a gasoline stabilizer

that is formulated for that purpose, or you can avoid fuel

deterioration problems by draining the fuel tank and carburetor.

When adding a gasoline stabilizer, fill the fuel tank with fresh

gasoline. If only partially filled, air in the tank will promote fuel

deterioration during storage. If you keep a container of gasoline

for refueling, be sure that it contains only fresh gasoline.

Add gasoline stabilizer following the manufacturer’s instructions.

After adding a gasoline stabilizer, run the engine outdoors for 10

minutes to be sure that treated gasoline has replaced the

untreated gasoline in the carburetor.

Stop the engine.

Check that the air vent tube is

secured by the tube retainers

without collapsing or kinking.

Start the engine outdoors,

andallowittowarmupto

operating temperature.

Standard idle speed:

With the engine idling, turn

the throttle stop screw to

obtain the standard idle

speed.

1,500 150 rpm

05/02/09 13:18:39 32Z4F800_009

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GX120 Regular Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GX120 Regular

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info