13107
12
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
−−
ENGLISH
Cleaning
SEDIMENT CUP
Low Profile Types
Recommended Spark Plugs:
SPARK PLUG
SEDIMENT CUP
O-RING
SPARK PLUG WRENCH
SEALING
WASHER
FUEL VALVE LEVER
SIDE ELECTRODE
OFF
0.70 0.80 mm
(0.028 0.031 in)
CLIP
CLIP
AIR FILTER ELEMENT
AIR CLEANER COVER
ELEMENT
12
Place the O-ring in the fuel valve, and install the sediment cup.
Tighten the sediment cup securely.
Wash the sediment cup and O-ring in nonflammable solvent,
and dry them thoroughly.
Move the fuel valve to the OFF position, then remove the fuel
sediment cup and O-ring.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Stop engine and keep heat, sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
Unsnap the air cleaner cover
clips, remove the air cleaner
cover, and remove the air
filter element.
Wash the element in a
solution of household
detergent and warm water,
then rinse thoroughly, or
wash in nonflammable or
high flashpoint solvent. Allow
the element to dry thoroughly.
Soak the air filter element in
clean engine oil and squeeze
out the excess oil. The engine
will smoke during initial
startup if too much oil is left
in the element.
Reinstall the air filter element
and the cover.
Attach the spark plug cap to the spark plug.
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
When reinstalling the original spark plug, tighten 1/8 1/4 turn
after the spark plug seats to compress the washer.
When installing a new spark plug, tighten 1/2 turn after the spark
plug seats to compress the washer.
After the spark plug is seated, tighten with a 13/16-inch spark
plug wrench to compress the sealing washer.
Install the spark plug carefully,
by hand, to avoid cross-
threading.
0.70 0.80 mm (0.028 0.031 in)
The gap should be:
Measure the spark plug
electrode gap with a wire-
type feeler gauge. Correct the
gap, if necessary, by carefully
bending the side electrode.
Inspect the spark plug.
Replace it if damaged, badly
fouled, if the sealing washer
is in poor condition, or if the
electrode is worn.
Remove the spark plug with a
13/16-inch spark plug wrench.
Disconnect the spark plug cap,
and remove any dirt from
around the spark plug area.
For good performance, the spark plug must be properly gapped
and free of deposits.
An incorrect spark plug can cause engine damage.
The recommended spark plug is the correct heat range for normal
engine operating temperatures.
W20EPR-U (DENSO)
BPR6ES (NGK)
Move the fuel valve to the ON position, and check for leaks.
Replace the O-ring if there is any leakage.
1.
2.
4.
3.
1.
2.
4.
3.
5.
6.
7.
8.
9.
1.
2.
4.
3.
05/06/17 17:26:00 32Z4F601_012
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honda Honda Engines GX200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Honda Honda Engines GX200

Honda Honda Engines GX200 Bedienungsanleitung - Deutsch, Holländisch - 60 seiten

Honda Honda Engines GX200 Bedienungsanleitung - Holländisch - 33 seiten

Honda Honda Engines GX200 Bedienungsanleitung - Italienisch - 60 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info