Bedienungsanleitung Honda Honda Engines GX240 (Seite 9 von 60) (Französisch, Spanisch)

13111

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

ENGLISH

REDUCTION CASE OIL (applicable types)

Recommended Oil

Oil Level Check

2 : 1 Reduction Case With Centrifugal Clutch

Oil Change

WASHER

OIL LEVEL

DRAIN PLUG

OIL FILLER CAP/

DIPSTICK

UPPER LIMIT

OIL FILLER CAP/DIPSTICK

LOWER LIMIT

OIL FILL HOLE

(bottom edge)

LOWER LIMIT

UPPER LIMIT

OIL FILLER CAP/DIPSTICK

Install the oil filler cap/dipstick and tighten securely.

Use the same oil that is recommended for the engine (see page ).

Check the reduction case oil level with the engine stopped and in a

level position.

Remove the oil filler cap/dipstick and wipe it clean.

Insert and remove the oil filler cap/dipstick without screwing it

into the filler hole. Check the oil level shown on the oil filler cap/

dipstick.

If the oil level is low, add the recommended oil to reach the

upper limit mark on the dipstick.

Screw in the oil filler cap/dipstick and tighten securely.

Check the engine oil level with the engine stopped and in a level

position.

Remove the oil filler cap/dipstick and wipe it clean.

Insert the oil filler cap/dipstick into the oil filler neck as shown,

but do not screw it in, then remove it to check the oil level.

Reinstall the oil filler cap/dipstick.

If the oil level is near or below the lower limit mark on the

dipstick, fill with the recommended oil (see page ) to the

upper limit mark (bottom edge of the oil fill hole). Do not overfill.

Running the engine with a low oil level can cause engine damage.

This type of damage is not covered by the

Distributor’s Limited

Warranty.

The Oil Alert system (applicable types) will automatically stop

the engine before the oil level falls below the safe limit.

However, to avoid the inconvenience of an unexpected

shutdown, fill to the upper limit, and check the oil level regularly.

Running the engine with a low oil level can cause engine

damage. This type of damage is not covered by the

Distributor’s

Limited Warranty.

With the engine in a level position, fill with the recommended oil

(see page ) to the upper limit mark (bottom edge of the oil fill

hole) on the dipstick.

Please dispose of used motor oil in a manner that is compatible

with the environment. We suggest you take used oil in a sealed

container to your local recycling center or service station for

reclamation. Do not throw it in the trash, pour it on the ground,

or pour it down a drain.

Allow the used oil to drain completely, then reinstall the oil drain

plug and new washer, and tighten the oil drain plug securely.

Place a suitable container below the engine to catch the used oil,

then remove the oil filler cap/dipstick, oil drain plug and washer.

Drain the used oil when the engine is warm. Warm oil drains

quickly and completely.

The Oil Alert system (applicable types) will automatically stop the

engine before the oil level falls below the safe limit. However, to

avoid the inconvenience of an unexpected shutdown, always

check the engine oil level before startup.

07/06/08 09:49:14 32Z5F600_009

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GX240 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GX240

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info