Bedienungsanleitung Honda Honda Engines GX670 (Seite 9 von 58) (Englisch)

13139

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

ENGLISH

AIR CLEANER

Inspection

Snorkel Type:

Cleaning

Standard Type:

AIR CLEANER COVER

PAPER FILTER ELEMENT

AIR CLEANER CASE

WING NUTS

AIR CLEANER COVER

FOAM FILTER ELEMENT

PAPER FILTER ELEMENT

AIR CLEANER CASE

Wipe dirt from the inside of the air cleaner body and cover,

using a moist rag. Be careful to prevent dirt from entering the air

chamber that leads to the carburetor.

Place the foam air filter element in the air cleaner cover, then

reinstall the paper air filter element and cover to the air cleaner

case. Hook the four latch tabs securely.

Remove the wing nut from the air cleaner cover, and remove the

cover.

Remove the wing nut from the paper filter element.

Remove the paper filter element from the air cleaner case.

A dirty air cleaner will restrict air flow to the carburetor, reducing

engine performance. If you operate the engine in very dusty areas,

clean the air filter more often than specified in the MAINTENANCE

SCHEDULE.

Operating the engine without an air filter, or with a damaged air

filter, will allow dirt to enter the engine, causing rapid engine wear.

This type of damage is not covered by the

Distributor’s Limited

Warranty.

Inspect both air filter elements, and replace them if they are

damaged. Always replace the paper air filter element at the

scheduled interval (see page ).

Clean the air filter elements if they are to be reused.

Paper air filter element: Tap the filter element several times on a

hard surface to remove dirt, or blow compressed air [not

exceeding 207 kPa (2.1 kgf/cm

, 30 psi)] through the filter

element from the air cleaner case side.

Never try to brush off dirt; brushing will force dirt into the fibers.

Replace the paper element if it is excessively dirty.

Foam air filter element: Clean in warm soapy water, rinse, and

allow to dry thoroughly. Or clean in nonflammable solvent and

allow to dry. Do not put oil on the foam element.

Reinstall the air cleaner cover, and tighten the cover wing nut

securely.

Reinstall the paper air filter element. Tighten the air filter wing

nut securely.

Wipe dirt from the inside of the air cleaner case and cover, using

a moist rag. Be careful to prevent dirt from entering the air duct

that leads to the carburetor.

Tap the filter element several times on a hard surface to remove

dirt, or blow compressed air [not exceeding 207 kPa (2.1 kg/cm

30 psi)] through the filter element from the inside. Never try to

brush off dirt; brushing will force dirt into the fibers.

Clean the paper air filter element if it is to be reused.

Inspect the paper air filter element, and replace it if it is

damaged. Always replace the paper air filter element at the

scheduled interval (see page ).

Remove the air cleaner cover and inspect the filter elements.

Clean or replace dirty filter elements. Always replace damaged

filter elements.

Release four latch tabs from the air cleaner cover, and remove

the cover.

Remove the foam filter from the cover.

Remove the paper filter from the air cleaner case.

05/03/22 19:38:27 32Z6C600_009

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GX670 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GX670

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info