Bedienungsanleitung Honda Honda Engines GXV530 (Seite 12 von 58) (Französisch, Spanisch)

13161

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

−−

Storage Precautions

TRANSPORTING

Removal from Storage

Draining the Fuel Tank and Carburetor

Engine Oil

ENGLISH

CARBURETOR

DRAIN SCREW

If your engine will be stored with gasoline in the fuel tank and

carburetor, it is important to reduce the hazard of gasoline vapor

ignition. Select a well-ventilated storage area away from any

appliance that operates with a flame, such as a furnace, water

heater, or clothes dryer. Also avoid any area with a spark-

producing electric motor, or where power tools are operated.

If possible, avoid storage areas with high humidity, because that

promotes rust and corrosion.

Keep the engine level in storage. Tilting can cause fuel or oil

leakage.

With the engine and exhaust system cool, cover the engine to

keep out dust. A hot engine and exhaust system can ignite or melt

some materials. Do not use sheet plastic as a dust cover.

A nonporous cover will trap moisture around the engine,

promoting rust and corrosion.

Gasoline is highly flammable and explosive, and you

can be burned or seriously injured when handling

fuel.

If the fuel was drained during storage preparation, fill the tank with

fresh gasoline. If you keep a container of gasoline for refueling, be

sure it contains only fresh gasoline. Gasoline oxidizes and

deteriorates over time, causing hard starting.

Check your engine as described in the

BEFORE OPERATION

CHECKS

section of this manual (see page ).

Remove the battery and store it in a cool, dry place. Recharge the

battery once a month while the engine is in storage. This will help

to extend the service life of the battery.

If the cylinders were coated with oil during storage preparation,

the engine may smoke briefly at startup. This is normal.

If the engine has been running, allow it to cool for at least 15

minutes before loading the engine-powered equipment on the

transport vehicle. A hot engine and exhaust system can burn you

and can ignite some materials.

Keep the engine level when transporting to reduce the possibility

of fuel leakage. If the fuel tank is equipped with a fuel valve, move

the fuel valve to the CLOSED or OFF position.

Wipe up spills immediately.

Handle fuel only outdoors.

Stop engine and keep heat, sparks, and flame away.

Disconnect the fuel line to the engine, and drain the fuel tank

into an approved gasoline container. If the fuel tank is

equipped with a valve, turn the fuel valve to the OPEN or ON

position to enable draining. After draining is completed,

reconnect the fuel line.

Loosen the carburetor drain screw, and drain the carburetor

into an approved gasoline container.

After all the fuel has drained into the container, tighten the

drain screw securely.

Change the engine oil (see page ).

Remove the spark plugs (see page ).

Pour a tablespoon 5 10 cm

(5 10 cc) of clean engine oil into

each cylinder.

Turn the engine for a few seconds by turning the engine switch

to the START position to distribute the oil in the cylinders.

Reinstall the spark plugs.

08/06/18 15:36:13 32Z5Z600_012

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honda Honda Engines GXV530 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda Honda Engines GXV530

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info