Bedienungsanleitung Honda HRX537 HYEA (Seite 18 von 23) (Englisch)

580898

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

ENGLISH

Loading and Unloading

Position the mower so all four wheels are on the bed of the transport

vehicle. Tie the mower down with rope or straps, and block the

wheels. Keep the tie-down rope or straps away from the controls,

adjustment levers, cables, and the carburetor.

NOTICE

To prevent losing control of or damaging the mower, do not use the

drive system when going up or down a loading ramp.

To prevent damaging the drive system, do not engage the clutch

when the mower is rolling backwards.

1. Turn the fuel valve to the OFF position.

2. Use a suitable loading ramp.

Adjust the loading ramp so

that it is inclined at an angle of

less than 15°. If a loading

ramp is not available, two

people should lift the mower

on and off the transport vehicle while keeping the mower level.

STORAGE

Proper storage is essential for keeping your lawn mower troublefree

and looking good. The following steps will help protect the mower

from rust and corrosion, and make the engine easier to start when you

use the lawn mower again.

Cleaning

1. Wash the lawn mower, including the underside of the mower deck.

Engine

Wash the engine by hand, and be careful to prevent water from

entering the air cleaner.

NOTICE

Using a garden hose or pressure washing equipment can force

water into the air cleaner. Water in the air cleaner will soak the

filters and can enter the carburetor or engine cylinder, causing

damage.

Water contacting a hot engine can cause damage. If the engine

has been running, allow it to cool for at least a half hour before

washing.

Mower Deck

If using a garden hose or pressure washing equipment to clean the

mower deck, be careful to avoid getting water into controls and

cables, or anywhere near the engine air cleaner or muffler

opening.

Before washing the underside of the mower deck, be sure the

throttle lever is in the STOP position and the fuel valve is in the

OFF position. Tilt the mower to the right so the fuel cap is up. This

will help to prevent fuel leakage and hard starting due to carburetor

flooding. Wear heavy gloves to protect your hands from the

blade(s).

Grass Bag

Remove the bag from the mower, and wash it with a garden hose

or pressure washing equipment. Allow the bag to dry completely

before storage.

2. After washing the lawn mower, wipe dry all accessible surfaces.

3. With the mower in an upright position, start the engine outdoors,

and let it run until it reaches normal operating temperature to

evaporate any water remaining on the engine.

4. Stop the engine and allow it to cool.

5. After the lawn mower is clean and dry, touch up any damaged

paint, and coat other areas that may rust with a light film of oil.

Charging the Battery (HZEA type)

To assure maximum reliability, the battery should be recharged (boost

charged) both before and after prolonged storage (see page 16).

Petrol

NOTICE

Depending on the region where you operate your equipment, fuel

formulations may deteriorate and oxidize rapidly. Fuel deterioration

and oxidation can occur in as little as 30 days and may cause damage

to the carburetor and/or fuel system. Please check with your servicing

dealer for local storage recommendations.

Petrol will oxidize and deteriorate in storage. Old petrol will cause

hard starting, and it leaves gum deposits that clog the fuel system. If

the petrol in your mower deteriorates during storage, you may need to

have the carburetor and other fuel system components serviced or

replaced.

The length of time that petrol can be left in your fuel tank and

carburetor without causing functional problems will vary with such

factors as blend, your storage temperatures, and whether the fuel

tank is partially or completely filled. The air in a partially filled fuel tank

promotes fuel deterioration. Very warm storage temperatures

accelerate fuel deterioration. Fuel deterioration problems may occur

within a few months, or even less if the petrol was not fresh when you

filled the fuel tank.

To prevent fuel related problems:

1. Add petrol stabilizer following the manufacturer’s instructions.

When adding a petrol stabilizer, fill the fuel tank with fresh petrol. If

only partially filled, air in the tank will promote fuel deterioration

during storage.

2. After adding a petrol stabilizer, run the engine outdoors for

10 minutes to be sure that treated petrol has replaced the

untreated petrol in the fuel system.

3. Turn the fuel valve to the OFF position.

4. Continue to run the engine until it stops

from the lack of fuel in the carburetor

fuel bowl. Running time should be less

than 3 minutes.

The warranty does not cover fuel

system damage or engine

performance problems resulting from

neglected storage preparation.

Engine Oil

Change the engine oil (page 13).

Engine Cylinder

If the mower is to be stored for more than

3 months, remove the spark plug

(page 14). Pour 5 ~ 10 cm³ of clean

engine oil into the cylinder [1]. Pull the

starter rope several times to distribute

the oil in the cylinder. Reinstall the spark

plug.

Pull the starter rope slowly until

resistance is felt, then return the starter

grip gently. This will close the valves so moisture cannot enter the

engine cylinder.

15°

OFF

[1]

HYEHZE bk1.book Page 18 Monday, September 8, 2008 9:46 AM

Honda HRX537 HYEA Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Honda HRX537 HYEA

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info