FINAL DRIVE OIL
Refer to the Safety Precautions on page 91.
Change the oil as specified in the maintenance
schedule.
Change the oil with the final drive at normal
operating temperature and the motorcycle
upright on level ground to assure complete and
rapid draining.
1. To drain the oil, remove the oil filler cap (1)
and oil drain plug (2).
2. After the oil has completely drained, check
that the sealing washer (3) on the drain plug
is in good condition and install the drain
plug.
Drain plug torque:
12 N·m (1.2 Kgf·m , 9 lbf·ft)
3. With the motorcycle upright on level ground,
fill the final drive with the recommended
grade oil; approximately:
130 cm
3
(4.4 US oz , 4.6 Imp oz)
Make sure the final drive is filled up to the
lower edge of the oil filler inspection hole (4)
with the recommended oil.
4. Install the oil filler cap.
(1) Oil filler cap
(2) Oil drain plug
(3) Sealing washer
(4) Oil filler inspection hole
