474024
18
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
SELECTING RECOVERY SETTING
29
30
Your T8631A Thermostat includes a screw on the back
marked 2A, allowing for the Adaptive Intelligent Recov-
ery™/Conventional Recovery choice.
Your thermostat was shipped from the factory with the
screw positioned for Adaptive Intelligent Recovery
setting. Your installer may have left the screw in this
position, or may have changed it to Conventional
Recovery. Before programming, you must know which
recovery method your thermostat has been set for.
With the Adaptive Intelligent Recovery setting, the
dwelling will reach the comfort temperature at the
exact time you have programmed into the thermo-
stat.
With Conventional Recovery, the programmed time
will be the time your furnace comes on to start
recovery; therefore, you should program the start
time to be earlier than the desired comfort time. It
may require some trial and error for you to arrive at
the best starting time, and the best starting time will
vary as the seasons change.
SYSTEM
GRAVITY
AIR/WATER
HOT
WATER
GAS/OIL
WARM AIR
ELECTRIC
WARM AIR
1A
OUT
1 TURN
OUT
1 TURN
OUT
1 TURN
OUT
1 TURN
1B
IN
IN
(FACTORY SETTING)
IN
IN
M3064
1A
1B
2A
2B
DISPLAY TEMPERATURE
2B
o
C
F
o
OUT
IN
2B
2A
OUT
IN
2A
RECOVERY OPTION
ADAPTIVE
CONVENTIONAL
HEAT
CYCLE RATE
To determine which type of recovery is
set into your T8631A Thermostat,
make sure your thermostat is mounted
and powered on the wall.
Press key. Check thermostat display.
If the shows in the lower right-
hand corner (see illustration), the
thermostat is set for Conventional
Recovery. If you would rather have
the Adaptive Intelligent Recovery
setting, remove thermostat from
wall, turn screw 2A (on back of
thermostat) clockwise until it
bottoms. DO NOT OVERTIGHTEN.
If the does not show, the
thermostat is set for Adaptive
Intelligent Recovery™. If you would
rather have Conventional Recov-
ery, remove thermostat from wall,
turn screw 2A (on back of thermo-
stat) out 1/2 to 1 turn.
MON
WAKE
AM
M5058
INDICATES
THERMOSTAT IS SET FOR
CONVENTIONAL RECOVERY
RUN
PROGRAM
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honeywell Chronotherm III - 69-0690 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info