Bedienungsanleitung Honeywell HEV615 series (Seite 6 von 29) (Englisch, Französisch, Spanisch)

723827

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

10 11

To keep your humidiﬁer running efﬁciently, clean it regularly. Weekly cleaning is

recommended. All maintenance should be done in the kitchen or bathroom on a water

resistant surface near a faucet.

To properly clean your humidiﬁer we recommend the separate processes of Scale Removal

and Disinfecting. These two processes must be performed separately.

Before Cleaning

1. Turn off and unplug humidiﬁer. NEVER clean the humidiﬁer when it is running.

2. Remove Water Tank and Tank Cover. Empty water from Tank.

3. Remove Wicking Filter. Pull the Filter Cartridge Handle straight up slowly, listening for

water dripping from the ﬁlter.

CAUTION: Filter may be saturated with water. Remove slowly to give ﬁlter

time to drain before removing. This will help prevent dripping on your ﬂoor

or other surfaces.

4. Remove Housing from Base.

a. Turn Locking Knob to the right toward the unlock symbol.

b. Lift Housing from the Base and set aside.

5. Holding the Base, empty water from the Reservoir.

CLEANING YOUR HUMIDIFIER

Step 1

CLEANING YOUR HUMIDIFIER (CONTINUED)

Scale Removal

Follow steps 1-5 in Before Cleaning section, then follow the additional steps below

Note: Filter must be removed from humidiﬁer before cleaning; DO NOT clean Filter with vinegar.

1. Pour a minimum of 3 cups (.7 liters) of undiluted distilled white vinegar in the Water Tank.

Gently swish vinegar around in the Tank to wet entire inside of Tank.

2. Place Tank on Base. Vinegar will drain into the Water Reservoir and loosen mineral buildup

(scale) in the Reservoir and bottom of the Water Tank. There should be enough vinegar to

cover the bottom inside of the Tank.

3. Soak for 20 minutes, then remove Water Tank and slowly empty vinegar into sink. Rinse

with tap water until the smell of vinegar is gone.

4. Remove Float Paddle from Reservoir by lifting up on Float Rod and set aside.

Wipe Float Paddle and Reservoir area with a soft cloth to remove loosened minerals.

5. Empty vinegar from Base and Reservoir area; rinse with water until the smell of vinegar

is gone.

6. Place Float Paddle back in Reservoir, ensuring Float Rod is secured in brackets.

For detailed instructions, refer to the Float Paddle Installation section.

CAUTION: Improper placement of the Float Paddle could result in leaking

or water not feeding to the Reservoir.

Step 4

Step 4a

Step 4b

Step 2

Step 3

Lift

Slowly

Step 2

Step 1

Step 3

MINUTES

Step 6

“Click”

Step 5

CARING FOR YOUR FILTER (CONTINUED)

Be sure to use only genuine Honeywell Replacement Filters

which are Protec

antimicrobially treated. It helps prevent

the migration of mold, algae and bacteria on the ﬁlter.

However, the Filter still needs to be replaced regularly.

Humidiﬁer Filters and accessories require replacement

and are not covered under warranty.

Find replacement ﬁlters at retailers or at

www.HoneywellPluggedIn.com

Replacement Filter

HFT600 or HFT600C

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HEV615 series Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info