Bedienungsanleitung Honeywell HFD320 - Air Genius 5 (Seite 6 von 24) (Englisch, Spanisch)

723816

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

• The timer option on the left of the control panel (see Fig. 5) allows you to select

how long the unit will run before it turns off automatically.

• ‘Tap’ the Timer symbol ( ) to shift through the options. When pressed the time

will move to the next highest setting until it is on ‘12’ (which means it will stay

on for 12 hours and then shut-off). If you tap the Timer symbol while it is on

‘12’ the timer option will turn off and the unit will run continuously. If you ‘tap’ it

again, it will start back at ‘2’.

• Toggle through the hour options until the LED light is illuminated behind the

number of hours you want the unit to operate for. If the Auto-off Timer is not

illuminated, the air purifier will run continuously.

SETTING THE TIMER OPTION

Fig. 5

ELECTRONIC FILTER CLEAN REMINDER

• This model air cleaner has an electronic filter check to remind you when to

check the washable ifD

filter based on the air purifier’s hours of use.

• When the ifD

filter needs to be cleaned, the LED light ‘bar’ will remain full and

the light will be illuminated until it is RESET. You may unplug the air cleaner

without interrupting the filter check.

• You should periodically check the filter. Depending on operating conditions,

the filter should be cleaned at least once every three months.

To RESET the Electronic Filter Check:

• When the filter monitor light remains on, it is time to check/clean the

ifD

filter and reset the filter monitor, if needed.

• After the filter has been cleaned and placed back in the unit (dry), you will want

to reset the indicator. To do this, ‘touch’ the ‘OK’ button for 2 or more seconds

until the LED light is off and the fill ‘chart’ is not illuminated.

Fig. 6

Fig. 7

REMOVING THE FILTER

CAUTION: Turn off the unit and wait 60 seconds before removing

the grille to clean filters.

The ifD

filter is supplied within the air cleaner.

• Turn-off the air cleaner. Wait 60 seconds and unplug the unit before removing

the grille. While pressing down on the notch along the rear grille, pull the grille

down and towards you and remove it (Fig. 8). Gently push along the edge of

the filter frame and pull forward.

• To place the filter back into the air cleaner housing, insert at the bottom and ensure that it is pushed

in as far as it can go and then push in from the top. To replace filter grille, align pin on bottom of grille

with opening on the housing and snap back into place. If the filter grille is not properly inserted, your air

purifier may not turn on. Ensure it is properly installed and there is no gap between grille and the housing.

NOTE: If the odor reducing pre-filter is used in lieu of the permanent washable pre-filter, it will need to be

replaced approximately every 3 months.

Fig. 8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HFD320 - Air Genius 5 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info