755972
25
Zoom out
Zoom in
Vorherige Seite
1/119
Nächste Seite
6
USE & OPERATION
CONTROL PANEL
FUNCTION BUTTONS
(2) (3)(4) (5)(6)(1)
oC
oF
(2) (3)(4) (5)(6)(1)
oC
oF
Model with Heat Mode Model without Heat Mode
The Power Control turns the unit on and off. When the unit is plugged into an appropriate electrical
outlet, the POWER indicator light will illuminate red indicating the unit is in a Standby Mode, ready to be
switched on at anytime. The air vent will automatically open when the unit is turned ON and automatically
close when unit is turned OFF.
POWER CONTROL
EN
The Timer is adjustable between 1 - 24 hours.
AUTO TURN OFF:
While unit is running, press the TIMER button and the display will flash. While the display is flashing,
press the + or - button to select the number of hours you want the unit to turn OFF automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the TIMER button and the
display will flash. While the display is flashing, press the + or - button to select the number of hours until
you want the unit to turn ON automatically.
TIMER CONTROL
TEMPERATURE CONTROL
Used for adjusting the timer and thermostat.
The default display is setting temperature.
In cooling mode, when + or - button is pressed, the set temperature is displayed and may be adjusted.
Note: By pressing both + / - buttons at the same time, the display will toggle between Celsius(°C)
and Fahrenheit(°F).
Condensation may accumulate in the unit.
If the bottom internal tank is full, the WATER FULL light will illuminate and an alarm will beep for
30 seconds. The unit will not operate until the water has been drained from the bottom drain plug (refer to
Water Condensation Drainage).
After switching the Honeywell Portable Local Air Conditioner off, the compressor will not start
immediately. You must wait about 4 minutes before it switches back on again.
WATER FULL LIGHT
1) Timer Control /Sleep Control 2) Fan Speed Control 3) Timer / Temperature Set Controls
4) Mode Control 5) Power Control 6) Warning Light
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Honeywell HQ12CESWG wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info