Bedienungsanleitung Honeywell HZ-970 Series (Seite 7 von 24) (Englisch, Französisch, Spanisch)

724039

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Model(s) HZ-960 Series, HZ-970 Series,

HZ-980 Series

Unit dims 15.875”H x 12.625”W x 15.25”D,

16.5 lbs

Amps 12.5

Unit Voltage 120V, 60Hz

Max Watts 1500

Max BTUs 5118

Operation Cost*

To estimate the cost to operate this heater, multiple the

watts used times .001 to convert into a kilowatts measure

and multiple by your local kilowatt electric rate for however

long you run the heater. For example, if your electric rate

is $.1196**per kilowatt hour and you ran this heater in

constant high mode (1500 watts) for 4 hours, it would cost

you $.71 cents to run the heater (1500 watts x 4 hours x.001) x

.1196kwp = .71 cents).

NOTE: Because the Low or EnergySmart® (HZ-970/HZ-980

Series) Settings do not require as much electricity to operate,

they are more energy ecient and may be better options if you

are concerned about the amperage draw on a circuit when the

heater is on the High setting.

*Calculation (Total Wattage x .001) x Cost per Kilowatt Hour =

Cost to operate

**Average Retail Price of Electricity to Ultimate Customer by

End-Use, US Energy Information Administration, March 2013.

† Compared to a standard 1500W heater. Amount of savings

will be based on various factors, including the room

temperature near the heater, room size, and the degree of

room insulation which can be affected by drafty windows,

doors, etc.

PRODUCT SPECIFICATIONS

TROUBLESHOOTING

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) This device must

accept any interference received, including interference that

may cause undesired operation.

Problem Solution

Heater does not turn on • Check to conrm heater is plugged in

• Conrm the electrical outlet is working

• Check battery in remote is working; replace as needed with lithium button type CR2025

Heater shuts o during operation • Check to conrm heater is plugged in

• Conrm electrical outlet is working

• Check for obstructions. If an obstruction is found, turn heater OFF, unplug, allow to cool and

remove obstruction. Wait 10 minutes, plug in heater and follow Operation Instructions.

• Check to conrm Filter is clear from debris. If clogged with debris, follow above Cleaning

Instructions.

• Conrm heater is not tipped and safety tip over switch is activated. If error code E1 is

illuminated in Temperature Display, the heater is in tipped position and will remain o

until moved into upright position.

• Room has met Desired Temperature and heater is in At Temp mode.

Airow is diminished • Check Filter, clean as necessary.

Liquid is spilled on heater • Shut heater OFF and unplug. Immediately wipe spill and allow to dry 24 hours before

plugging in.

Lost Remote • Call 1-800-477-0457 for a replacement.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell HZ-970 Series Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info