Bedienungsanleitung Honeywell THR830TUK (Seite 2 von 2) (Englisch)

585446

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Wiring

1.0 - 2.5 mm²

8 mm max.

Wiring diagrams

Test system and ﬁnish installation

• AllwiringmustbeinaccordancewithIEERegulations.Thisthermostatisforxedwiringonly.

• Aswitch,havingcontactseparationofatleast3mminallpolesmustbeincorporatedinthexedwiringasa

means of disconnecting the supply.

• ThethermostatisaClassII(doubleinsulated)device.Aparkingterminalisprovidedforexternalearthwiring

continuity.

• Theheatingsystemmustincorporateafuseratedatnomorethan10Amps.Thecoolingsystemmust

incorporate a fuse rated at no more than 6 Amps.

• Thethermostathas4knockoutsonthecovertoaccommodatesurfacewiring.Makesurethecablecompletely

ﬁlls the knockout hole without leaving any gaps. Where used, mini-trunking must be ﬁtted ﬁrmly against the

thermostat cover in such a way as to leave no gap.

1 Replace cover and secure with

screw as shown at left.

2 Check the power supply to make

sure the heating system is on.

3 Turn the control dial to raise

targettemperatureto30°C.If

the thermostat is wired properly,

the heating system should begin

running.

4 To stop the test, turn the control

dial to lower the target temperature

to an appropriate level. The heating

system should turn off.

Turn dial to 30°C to test

Replace and secure cover

Connect wiring from your heating or cooling

equipment to the thermostat as shown at left.

See wiring diagrams for details.

1 Make sure electrical power is off.

2 Strip insulation to expose about 6 mm of

bare wire.

3 Use a screwdriver to loosen terminal screw,

insert wire into slot, then tighten screw.

4 See below to test and ﬁnish installation

NOTE: All wiring must comply with IEE

regulations. Keep AC mains supply/load cables

separate from equipment wiring.

Honeywell

The Arnold Centre

Paycocke Road

Basildon,Essex

SS143EA

TechnicalHelpDesk:08456042893 50051981-001Rev.A

homexpert

Heating application Cooling application

Honeywell warrants this product for 1 year from date

of purchase. We undertake to replace or repair at our

discretion, products should they become defective

within 1 year solely as a result of faulty materials and or

workmanship.

Understandably if the product has not been installed or

maintained in accordance with Honeywell’s instructions,

has not been used appropriately or if any attempt has

been made to rectify, dismantle or alter the product in

any way the warranty will be invalidated.

This product warranty states Honeywell’s entire liability.

It does not extend to cover consequential loss or

damage or installation costs arising from a defective

product.

If the product is defective, please return it together with

a proof of purchase or receipt to the place of purchase.

This does not affect your statutory rights.

If you require further information about this product,

call the homexpert

by Honeywell technical helpline on

08456042893.

For a full list of terms and conditions please visit

www.homexpertbyhonyewell.com.

Limited warranty

HEATING LOAD

COOLING LOAD

230v~

50-60 Hz

230v~

50-60 Hz

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Honeywell THR830TUK Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info