! Pressing the CARE DOSE button you will
be able to set the autodose function,
according to your needs.
! If you want to change the factory settings,
hold the CARE DOSE button, until the
dedicated icons are blinking. Afterward,
you can choose the desired setting:
- Pressing once the CARE DOSE button,
the ONLY softener autodose will be
deselected.
- Pressing twice the CARE DOSE button,
the ONLY detergent autodose will be
deselected.
- Pressing three times the CARE DOSE
button, both the detergent and softener
autodose will be deselected.
- Pressing four times the CARE DOSE
button to go back to the factory settings
(both the detergent and softener
autodose are ON).
! The simultaneous press of SPIN
SELECTION and DELAY START buttons
for about 3 seconds can lock the buttons.
In this way, you can avoid involuntary or
accidental modifications.
! The button lock can be cancelled by simply
pressing the two activation buttons and
turning the appliance off.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF.
The display’s indicator system allows you to
be constantly informed about the status of the
machine.
1) DOOR LOCKED INDICATOR LIGHT
! The indicator light is illuminated when the
door is fully closed.
! When START/PAUSE is pressed
on the machine with the door closed,
the indicator will flash momentarily and
then illuminate.
! Wait until the DOOR LOCKED light has
gone out before opening the door.
2) WASH TEMPERATURE
This show the washing temperature of the
selected programme that can be changed
(where allowed) by the relevant button.
WARNING:
It’s necessary to clean and water the
autodose drawer every time the
softener/detergent drawers are refilled
or the type of softener/detergent are
changed.
Drawer must be closed properly
during the whole washing cycle,
otherwise dosing and warning system
cannot work properly.
If the door is not properly closed, the
light will continue to flash for about
7 seconds, after which the start
command will be automatically delete.
In this case, close the door in the proper
way and press the START/PAUSE button.
