Bedienungsanleitung Hoover DX C8DE-80 (Seite 12 von 18) (Englisch)

705510

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

CONTROLS AND

INDICATORS

A-Programme Selector - Rotating the knob

in both directions it's possible to select the

desired drying program. To cancel the

selections or switch off the dryer rotate the

knob on OFF.

B- Display Digit - The display shows the

remaining time for drying, the postponed

time in case of delayed start selection and

other notifications setting.

C-Buttons -

1.Start/Pause Button

To start the selected program and/or

suspend it.

2.Delay Start Button

It allows to delay the start of the program

from 1 to 24 hours in 1-hour intervals. The

delay selected is shown on the display.

After pressing the START button the time

showed decrease hour after hour.

Opening of the porthole with delayed start

set, after re-closing the porthole, press start

again to resume the counting.

3.Time cycle selection

It's possible transform a cycle from automatic

to programmed, up to 3 minutes after the

start of the cycle.

The progressive pressure increases the time

in 10-minute intervals.

After this selection to reset the automatic

dying functioning is necessary to switch off

the dryer In case of incompatibility, all LEDs

flash quickly for 3 times.

4.Drying Selection Button

It allows to set the desired dryness level

editable option up to 5 minutes after the

starting of the cycle:

- Ready to Iron : It leaves the garments

slightly wet to facilitate ironing.

- Dry Hanger : To get garment ready to be

hang

- Dry wardrobe : For laundry that can be

directly stored

-Extra-dry : To get completely dry

garments, ideal for full load.

This appliances is equipped with Drying

Manager Function. On automatic cycles,

each level of intermediate drying, prior to the

reaching the selected one, is indicated by

flashing the light indicator corresponding to

the degree of drying reached. In case of

incompatibility, all LEDs flash quickly for 3

times.

5.Rapids Button

It's possible switch an automatic program to

RAPID program, up to 3 minutes after the

start of the cycle. The progressive pressure

increases the time (30-45-59 minutes).

After this selection to reset the automatic

dying functioning is necessary to switch off

the dryer In case of incompatibility, all LEDs

flash quickly for 3 times.

6.Anti crease

This option allows to activate an anti-creases

movement of the drum pre cycle in case of

activation of the delay and at the end of

drying cycle. It is activated every 10 minutes,

up to 6 hours after the end of the drying cycle.

To stop the movements set the knob to OFF.

Useful when it's not possible to remove

immediately.

7. Keylock

This function allows to block unwanted

changes of the set options on the bezel ,

during drying phase.

Activation/ Inactivation: Push 4 and 5 buttons

simultaneously for two seconds . The sign

"LOC" appears on the display. Unlocking the

option, on the display appears the sign "Unl",

only once. In case of opening of 'porthole' with

activated key lock, the cycle stops but the lock

is kept: to restart the cycle, you must remove

the lock and restore Start. When the dryer is

off, the option is automatically inactivated.

Key lock can be modified at any time of the

cycle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover DX C8DE-80 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info