Bedienungsanleitung Hoover HAVG75S2B (Seite 8 von 168) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch)

817774

Zoom out

Zoom in

Vorherige Seite

1/168

Nächste Seite

Instructions for the installer

The hob may be installed in any worktop which is

heat resistant to a temperature of 100°C, and

has a thickness of 25-45 mm. The dimensions

of the insert to be cut out of the worktop are in

shown in Figure 2*.

If the hob is ﬁtted next to a cabinet on either

side, the distance between the hob and the

cabinet must be at least 15 cm; while the

distance between the cut out and the rear wall

must be at least 7 cm; while the distance

between the hob and the rear wall must be at

least 70 mm for frontal control hobs and 50 mm

for lateral control hobs.

how the sealant should be applied.

Installing a domestic appliance can be a

complicated operation which if not carried

out correctly, can seriouslyaﬀect consumer

safety. It is for this reason that the task

should be undertaken by a professionally

qualiﬁedperson who will carry it out in

accordance with the technical regulations in

force. In the event that this advice isignored

and the installation is carried out by an

unqualiﬁed person, the manufacturer

declines all responsibility for any technical

failure of the product whether or not it

results in damage to goods or injury to

individuals.

When a 75 cm hob is ﬁtted over a built in oven,

the latter must be fan cooled.

The distance between the hob and any other

unit or appliance above it (e.g. An extractor hood)

must be no less than 700 mm (Figure 4*).

When a 60 cm hob is ﬁtted over a built in oven,

Metal objects in the drawer may reach high

temperatures due to air recirculation. It is

therefore recommended to use an intermediate

wood panel.

The Hob unit is ﬁtted by attaching the Fixing

Clamps supplied, using the holes at the base of

the unit.

When there is an accessible space between the

built-in hob and the cavity below, a dividing wall

made of insulating material should be inserted

(wood or a similar material) (Figure 3*).

BUILDING IN

Important - The diagram in Figure 1* shows

If a hood can not be installed, an electric fan

should be ﬁtted to an outside wall or window to

ensure that there is adequate ventilation.

The electric fan should be able to carry out a

complete change of air in the kitchen 3-5 times

every hour. The installer should follow the

relevant national standards.

This appliance must be installed in accordance

with the regulations in force and only used in a

well ventilated space. Read the instructions

before installing or using this appliance.

the latter must be fan cooled.

SUITABLE LOCATION

A gas-powered cooking appliance produces

heat and humidity in the area in which it is

installed. For this reason you should ensure

good ventilation either by keeping all natural air

passages open or by installing an extractor

hood with an exhaust ﬂue. Intensive and

prolonged use of the appliance may require

extra ventilation, such as the opening of a

window or an increase in speed of the electric

fan, if you have one.

*See “Technical information” section at the end of this manual.

EN 7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover HAVG75S2B Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info