Bedienungsanleitung Hoover HL V10DG-80 (Seite 11 von 20) (Englisch)

705492

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

CONTROLS AND

INDICATORS

A-Programme Selector - Rotating the knob

in both directions it's possible to select the

desired drying program. To switch or cancel

off the dryer rotate the knob on OFF.

B- Display Digit - The display shows the

remaining time for drying, the postponed

time in case of delayed start selection and

other notifications setting.

C-Buttons -

1.Start/Pause Button

To start the selected program and/or

suspend it.

2.Delay Start Button

It allows to delay the start of the program

from 1 to 24 hours in 1-hour intervals. The

delay selected is shown on the display.

After pressing the START button the time

showed decrease hour after hour.

Opening of the porthole with delayed start

set, after re-closing the porthole, press start

againg to resume the counting.

3.Time cycle selection

It's possible transform a cycle from automatic

to programmed, up to 3 minutes after the

start of the cycle.

The progressive pressure increases the

time in 10-minute intervals.

After this selection to reset the automatic

dying functioning is necessary to switch

off the dryer In case of incompatibility, all

LEDs flash quickly for 3 times.

4.Drying Selection Button

It allows to set the desired dryness level

editable option up to 5 minutes after the

starting of the cycle:

-Ready to Iron : It leaves the

garments slightly wet to facilitate ironing.

-Dry Hanger : To get garment ready

to be hang.

-Dry wardrobe : For laundry that can

be directly stored

-Extra-dry : To get completely dry

garments, ideal for full load.

This appliances is equipped with Drying

Manager Function. On automatic cycles,

each level of intermediate drying, prior to

the reaching the selected one, is

indicated by flashing the light indicator

corresponding to the degree of drying

reached

5.Rapids Button

It's possible switch an automatic

program to RAPID program, up to 3

minutes after the start of the cycle. The

progressive pressure increases the time

(30-45-59 minutes).

After this selection to reset the automatic

dying functioning is necessary to switch

off the dryer In case of incompatibility, all

LEDs flash quickly for 3 times.

6.Anti crease

This option allows to activate an anti-

creases movement of the drum pre cycle

in case of activation of the delay and at

the end of drying cycle. It is activated

every 10 minutes, up to 6 hours after the

end of the drying cycle. To stop the

movements set the knob to OFF.

Useful when it's not possible to remove

immediately.

7. Keylock

This function allows to block unwanted

changes of the set options on the bezel ,

during drying phase.

Activation/ Inactivation: Push 4 and 5

buttons simultaneously for two seconds .

The sign "LOC" appears on the display.

Unlocking the option, on the display

appears the sign "Unl", only once.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover HL V10DG-80 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info