Bedienungsanleitung Hoover HLSI 550GT (Seite 12 von 17) (Englisch)

594585

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

"IMPULSE" programmes

The “IMPULSE” programmes use an

impluse washing technology, which reduces

consumption, noise and increases

performances.

IMPORTANT

The “intermittent” working of the

washing pump MUST NOT BE

considered a malfunction, it is a

characteristic of the impulse washing

so must be considered a normal

function of the programme.

Programme interruption

Opening the door when a programme is

running is not recommended especially

during the main wash and final hot rinse

phases. However, if the door is opened

while a programme is running (for example,

to add dishes) the machine stops

automatically and the display will flash the

remaining time before the end of the cycle.

Close the door, without pressing any

buttons. The cycle will start from where it

left off.

WARNING!

If you open the door during the

drying cycle, an audible audio signal

advises you that the drying cycle has

not yet finished.

Changing a running programme

Proceed as follows to change or cancel a

running programme:

■ Open the door.

■ Hold the "RESET" button down for at

least 5 seconds (the running programme

will be cancelled).

■ The display will show the "recommended"

programme.

■ At this point a new programme can be set.

WARNING!

Before starting a new programme,

you should check that there is still

detergent in the dispenser.

If necessary, top up the dispenser.

If there is any break in the power supply

while the dishwasher is operating, a

special memory stores the selected

programme and, when the power is

restored, it continues where it left off.

Programme end

A 5 second alarm will sound (if not muted)

3 times at 30 second intervals to signal that

the programme has ended.

Dishes can now be removed and the

dishwasher turned off by pressing the

"ON/OFF" button or dishes can be loaded

for a new cycle.

Option button

“SUPER ECO” button

This button provides an energy and time

saving of 25% on average (according to

the select cycle) reducing the wash water

temperature and the drying time during the

final rinse.

This programme is recommended for light

soil washes, and for slightly wet dishes that

are not fully dry, & improved drying results.

We advise you to leave the door of the

dishwasher half-open at the end of the

cycle, to allow for a natural circulation of air

inside the dishwasher.

"DELAY START" button

Dishwasher start time can be set with this

button, delaying start from 1 to 23 hours.

Proceed as follows to set a delayed start:

■ Press the "DELAY START" button ("00"

will appear on the display).

■ Press the button again to increase the

delay in hours (each time the button is

pressed the delay is increased by 1 hour

to a maximum of 23). The “DELAY

START” indicator light will turn on.

■ To start the countdown press the

"START" button (the “DELAY START”

indicator light will start to flash). At the

end of the countdown, the programme

will automatically start (the “DELAY

START” indicator light will turn off).

If you wish to see which programme has

been selected, press the "PROGRAMME

SELECTION" button.

Proceed as follows to cancel a delayed

start:

■ Hold the "RESET" button down for at

least 5 seconds.

■ The delayed start and the selected

programme will be cancelled.

The display will show the "recommended"

programme.

■ At this point, a new programme and

option buttons must be set to start a

new programme as indicated in the

"PROGRAMME SETTINGS" section.

Alarm mute for the PROGRAMME

END

The alarm for the programme end may be

muted as follows:

IMPORTANT

The dishwasher must be ALWAYS off

before start this procedure.

1. Hold down the "PROGRAMME

SELECTION" button and at the same

time switch on the dishwasher by

pressing the "ON/OFF" button (a brief

audible signal will sound).

2. Keep the "PROGRAMME SELECTION"

button pressed for at least 15 seconds

(during this time, 2 audible signals will

sound).

3. Release the button when the second

audible signal sounds ("b1" will appear on

the display to indicate that the alarm is on).

4. Press the same button again ("b0" will

appear on the display to indicate that the

alarm is off).

5. Turn off the dishwasher by pressing the

"ON/OFF" button to confirm the new

setting.

To turn the alarm on again, follow the same

procedure.

IMPORTANT

This dishwasher is equipped with an

anti-overflow safety device which will

automatically discharge any excess

water should a problem occur.

WARNING!

To ensure the correct operation of

the anti-overflow safety device, we

recommend that the dishwasher is

not moved or tilted during operation.

If however it is necessary to tilt or

move the dishwasher, please ensure

that the washing cycle is complete

and that there is no remaining water

inside the dishwasher.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover HLSI 550GT Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info