Bedienungsanleitung Hoover Purepower GREENRAY TGP 1410 (Seite 4 von 54) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

511131

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

CLEANER MAINTENANCE

Replacing The Dust Bag

If the bag check indicator is red please check and, if necessary, replace the bag.

1. Remove the hose from the main cleaner. [13]

2. Press the button [14] to open the cover and pull the bag collar to remove the bag. The

full dust bag should be disposed of correctly and carefully.

3. Fold a new bag as shown on the bag and t by inserting the collar into the bag holder [15].

4. Close the cover.

Remember: The bag check indicator may also ash if an obstruction has occurred. In this

case refer to ‘Removing A Blockage From the System’.

Cleaning the Filter

To maintain optimum performance of your cleaner, please wash the Pre-Motor lter after

each 5 bag changes.

To remove the Pre-Motor lter press the latch at the top of the pre-motor lter frame to

unlock it from the cleaner . Tilt then remove the lter from the cleaner. Wash it in hand warm

water, and allow it to dry thoroughly before replacing to the cleaner [16].

Remember: Do not use hot water or detergents. In the unlikely event of the lters becoming

damaged, t a Genuine Hoover replacement. Do not try and use the product without a dust

bag or lter tted.

Removing a Blockage From The System

If the bag check indicator is illuminated or ashing:

1. Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.

2. If it is not full, then;

A. Do the lters need cleaning? If so refer to ‘Cleaning the Filter’.

B. Check if there is any other blockage in the system - Use a rod or a pole to remove

any blockage from the Teletube or exible hose.

Warning - The bag check indicator will turn red if the cleaner is used when full, if there is

a blockage or if the lters are dirty. If the cleaner is used for a signicant period of time

with the bag check indicator is red, a thermal cut out will switch the cleaner off to prevent

overheating. The bag check indicator turn green once the cleaner has switched off to signal

that the thermal cut out has been activated. If this should happen, switch the cleaner off,

unplug and correct the fault. It will take about 30 minutes for the cut out to automatically

reset.

ACCESSORIES

Please see the model specication on the packaging label for inclusion of accessories to

individual models. All accessories can be purchased separately from Hoover. (See Hoover

Spares and Consumable section).

All accessories can be tted to the end of the hose or the end of the telescopic tube.

Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend

the brushes push the button on the body of the tool. [17]

Crevice Tool – For corners and hard to reach areas. [18]

Furniture Nozzle – For soft furniture and fabrics. [19]

Parquet Nozzle*– For wooden oors and other delicate oors [1T].

Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep

cleaning on textile surfaces and other hard to clean areas [1U].

Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for

deepcleaning on textile surfaces and other hard to clean areas. [1V]

Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1W]

IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long

fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary

while the brush is rotating.

USER CHECKLIST

Should you have a problem with the product, complete this simple user checklist

before calling your local Hoover service.

• Is there a working electricity supply to the cleaner? Please check with another electrical

appliance

• Is the dust bag over-lled? Please refer to ‘Cleaner Maintenance’

• Is the Filter blocked? Please refer to ‘Cleaning the lter’

• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’

• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically reset

•

(*Certain models only)

PurePower IM 17 languages greenray .indd 2 25/01/2011 08:35:03

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover Purepower GREENRAY TGP 1410 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info