Bedienungsanleitung Hoover WindTunnel 3 Pro Pet (Seite 30 von 56) (Englisch, Französisch, Spanisch)

594412

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

5. TROUBLESHOOTING

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the

checklist below.

Any other servicing should be done by an authorized service representative.

If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take

it to a service center prior to continuing use.

WARNING

! !

To reduce the risk of personal injury - Unplug before cleaning or servicing.

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION

Vacuum won’t

run

1. Power cord not firmly plugged

into outlet.

1. Plug unit in firmly.

2. Blown fuse or tripped breaker. 2. Check fuse or breaker in home.

Replace fuse/reset breaker in home.

3. Thermal Protector activated. 3. Unplug and allow vacuum to cool for

30min. (This willl reset the thermal protector)

System Check

Indicator has

turned red

Vacuum won’t

pick up

Low suction

1.Rinsable Filter and/ or Filter

made with HEPA media is dirty.

1. Clean Rinsable Filter and or Filter made

with HEPA media - Pg. 11.

2. Dirt cup full and/ or clogged. 2. Empty dirt cup - Pg. 10.

3. Broken or worn belt. 3. Replace belt - Pg.14.

4. Brushroll and/ or Hose clogged. 4. Check Hose - Pg.13. Check Brushroll - Pg. 12.

5. Carpet height setting is incorrect. 5. Set Carpet Height Adjustment to appropri-

ate setting for carpet being cleaned - Pg.7.

6. Suction Only Mode is ON. 6. Step on Brushroll ON/OFF Pedal to turn

Suction Only Mode OFF - Pg. 6.

Cord Rewind

does not work

1. Cord reel does not retract. 1. Call 1-800-944-9200 for the nearest

authorized service representative.

Dust escaping

from vacuum

1. Dirt cup full. 1. Empty dirt cup - Pg. 10.

2. Dirt cup not installed correctly. 2. Review Dirt Cup removal & replacement -

Pg. 10.

3. Hose not installed correctly. 3. Review Hose installation - Pg. 8.

4. Rinsable and/ or Filter made with

HEPA media not installed completely.

4. Review Filter Removal and Cleaning - Pg.

11.

Headlight not

working

1. Bulb burnt out. 1. Replace bulb - Pg. 13.

2. Loose electrical wires. 2. Call 1-800-944-9200 for nearest authorized

Hoover

dealer.

Vacuum is

difficult to

push or won’t

move

forward

1. Carpet height setting is incorrect. 1. Set Carpet Height Adjustment knob to

appropriate setting for carpet being

cleaned - Pg. 7.

2. Brushroll is activated. 2. For very high pile carpet deeper than 1”,

turn brushroll off.

Air-Powered

Hand Tool

brushroll

won’t turn

1. Too much pressure being applied to tool. 1. Continue using tool applying light pressure.

2. Blockage. 2. Remove blockage.

3. Low vacuum suction. 3. Check items under “Vacuum won’t pick up

or Low suction.”

Smoky/burn-

ing smell

detected

1. Belt broken or stretched. 1. Replace brushroll belt - Pg. 14.

2. Brushroll is clogged. 2. Clear/ remove debris from brushroll - Pg.12.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hoover WindTunnel 3 Pro Pet Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info