Bedienungsanleitung Horizon Fitness ROJO T4 (Seite 5 von 14) (Englisch)

642780

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Belt is too far to the right side

Belt is too far to the left side

TENSIONING THE RUNNING BELT

The running belt has been properly adjusted at the factory

before it was shipped. At times the belt can move off-center

during shipment.

CAUTION:Running belt should NOT be moving during tension-

ing. Over-tightening the running belt can cause excessive

wear on the treadmill as well as its components. Never over-

tighten the belt.

If you can feel a slipping sensation when running on the

treadmill, the running belt must be tightened. In most cases,

the belt has stretched from use, causing the belt to slip. This

is a normal and common adjustment. To eliminate this

slipping,TURN THE TREADMILL OFF and tension BOTH THE

REAR ROLLER BOLTS using the supplied Allen wrench,

turning them 1/4 TURN to the right as shown. Turn the tread-

mill on and check for slipping. Repeat if necessary, but NEVER

TURN the roller bolts more than 1/4 turn at a time. Belt is

properly tensioned when the slipping sensation is gone.

The running belt has been properly adjusted at the factory

before it was shipped. At times the belt can move off-center

during shipment. Before operating the treadmill, make sure

the belt is centered and remains centered to maintain

smooth operation.

CAUTION:Do not run belt faster than 1/2 mph while center-

ing. Keep ﬁngers, hair and clothing away from belt at all

times.

If the running belt is too far to the right side: With the

treadmill running at 1/2 mph, turn the right adjustment

bolt clockwise 1/4 TURN at a time (using the supplied Allen

wrench). Check the belt alignment. Allow belt to run a full

cycle to gauge if more adjustment is needed. Repeat if

necessary, until the belt remains centered during use.

If the running belt is too far to the left side: With the tread-

mill running at 1/2 mph, turn the right adjustment bolt

counter- clockwise 1/4 TURN at a time (using the supplied

Allen wrench). Check the belt alignment. Allow belt to run a

full cycle to gauge if more adjustment is needed. Repeat if

necessary, until the belt remains centered during use.

CENTERING THE RUNNING BELT

TREADMILL OPERATION

A LARGE LED WINDOWS:

Time & Distance.

B ALPHANUMERIC LED WINDOW:

Pace, % Complete, Heart Rate, Incline, Calories and Speed.

C FEEDBACK LEDS:

Indicate what workout feedback is currently being displayed.

D TRAINING MODE LEDS:

Indicate what training mode is currently selected.

E SAVED WORKOUT LEDS:

Indicate when a saved workout is selected.

F START:

Press start to begin exercising, starts your workout, or resume exercising after pause.S

G STOP:

Press to pause/end your workout. Hold for 3 seconds to reset the treadmill.

H INCLINE / KEYS:

Used to adjust incline in small increments (0.5% increments).

I SPEED + / - KEYS:

Used to adjust speed in small increments (0.1 mph increments or 0.1 kmph incremens).

J ENTER:

Used to conﬁrm selection and adjust settings. Press to change display feedback during workout.

K SELECT TRAINING MODE KEY:

Used to select between 3 training modes: Weight Loss, Event Training and

Cardio Training.

L SAVE WORKOUT KEY:

Used to select and use any of 4 pre-saved workouts. After your workout, press to save a

workout for future use.

M INCLINE MYKEYS™:

Used to reach desired incline more quickly. See next page for details.

N SPEED MYKEYS™:

Used to reach desired speed more quickly. See next page for details.

O IPOD CONTROLS:

Press to adjust your attached iPod® audio settings. See page 13 for more info (ROJO T5 only).

P IPOD DOCKING STATION:

Used to dock and charge your iPod®.

Q SPEAKERS:

Music plays through speakers when your CD / MP3 player is connected to the console.

R AUDIO IN JACK:

Plug your CD / MP3 player into the console using the included audio adaptor cable.

S AUDIO OUT / HEADPHONE JACK:

Plug your headphones into this jack to listen to your music through the head

phones. NOTE: When headphones are plugged into the headphone jack the sound will no longer come out

through the speakers.

T SAFETY KEY POSITION:

Enables treadmill when safety key is inserted.

Note: There is a thin protective sheet of clear plastic on the overlay of the console that should be removed.

iPo d Co ntrols

2/15/09 10:20 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Horizon Fitness ROJO T4 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Horizon Fitness ROJO T4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info