Bedienungsanleitung Hotpoint-Ariston ab 95 (Seite 20 von 32) (Englisch, Türkisch)

313565

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

The door block lamp

The safety lamp indicates that the

washing machine door is blocked

to prevent it from being opened

accidentally. To avoid any

damages, you must wait for the

lamp to switch itself off before

you open the door. You must

wait around three minutes.

Anti-crease

This function (represented by the

symbol

) interrupts the wash

programme, keeping the washing

soaking in water before draining.

It is only enabled in programmes

for synthetic fabrics, silk and

curtains. It is very useful,

because it prevents delicate and

synthetic fabrics from creasing

(for example, when you cannot

take the washing out at the end

of the wash cycle but only a few

hours later). The programme can

be completed by turning knob A

one notch. In the case of

synthetic fabrics, should you

prefer draining rather than a spin

cycle, turn knob A until you have

selected the symbol

(Drain).

Rapid wash

This button reduces the length of

the wash programme by about

30%. It cannot be used with

special programmes (see page 18)

or those for wool and silk.

Stain removal (see page 21)

Thanks to this command, Mar-

gherita will carry out a more in-

tensive wash that optimises the

effectiveness of the liquid

additives, thus allowing more

resistant stains to be removed.

When you press the stain removal

button, you cannot activate the

pre-wash cycle (G).

Pre-wash

With this button, you can pre-

wash on all programmes except

the wool programme and the

special programmes (see page

18).

On-off

When button H is pressed, the

washing machine is switched on,

when it is not the machine is

switched off.

Turning the appliance off does

not cancel the selected

programme.

The on-off lamp

Lamp I flashes when the appliance

is switched on and awaiting a

programme to be set. A steady light

means the appliance has accepted

the selected programme.

Here Im in command

Understanding the control panel

Making the right choice is important. And its easy.

Programme selector knob

and programmed start

Use this knob to select the wash

programme.

Turn this knob clockwise only.

To select a programme, you

should turn the knob so that the

symbol/number of the desired

programme is in line with the

pointer on the control panel.

Now press on/off button H

(position ON), pilot lamp I will

start flashing.

After 5", the setting will be

accepted, pilot lamp I will stop

flashing (staying lit) and the wash

cycle will begin.

Should you wish to interrupt the

programme in progress or set a

new one, select one of the

symbols

(Stop/Reset) and wait

5" : when the cancellation has

been accepted, pilot lamp I

flashes, and you can then turn the

appliance off.

You can use this knob to delay

the appliance's operation.

Select one of the four delay time

positions, press the on/off button

H (position ON) and wait 5". The

setting has now been accepted

(pilot lamp I stays lit) and you

can select the programme you

desire.

Pilot lamp I has a particular

flashing motion (2" on and 4"

off) to indicate that a delayed

start has been set.

During this phase, you can open

the appliance door and change

the washing load, should you

wish to do so.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position

Stop/Reset).

Temperature control knob

It is used to set the wash tempe-

rature indicated in the

programme table. It also allows

you to reduce the temperature

recommended for the selected

programme, and even to set a

cold wash cycle (

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-washing;

2. Detergent for the wash cycle;

3. Fabric softeners.

The washing machine is

equipped with extra

compartment 4 (provided) for

the bleach, to be inserted in

compartment 1.

Slow spin

Use this button to reduce the

spinning speed from 900 to 400

rpm for the cotton programmes

and from 750 to 400 rpm for the

synthetic fabrics programmes.

Margherita - Instructions for installation and use

ARGHERITA

The detergent dispenser with the

additional bleach compartment is

here.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston ab 95 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info