Bedienungsanleitung Hotpoint-Ariston al 109 x (Seite 4 von 16) (Englisch)

313572

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

ARGHERITA

Margherita - Instructions for installation and use

The on-off lamp

Lamp I flashes when the

appliance is switched on and

awaiting a programme to be set.

A steady light means the

appliance has accepted the

selected programme.

The door block lamp

The safety lamp indicates that the

washing machine door is locked

to prevent it from being opened

accidentally. To avoid any

damages to lock mechanism, you

must wait for the lamp to

extinguish, before attempting to

open the door which takes

around three minutes.

Silk and curtains: press button

D and Margherita will drain the

water.

Synthetic fabrics: press button D

if you want a spin cycle, or turn

knob A to symbol if you

want the water to be drained.

With "Daily wash" or "Hand

wash", this function is not

enabled.

Slow spin (1000/500)

Use this button to reduce the

spinning speed from 1000 to 500

rpm for the cotton programmes

and from 800 to 500 rpm for the

synthetic fabrics programmes.

Extra Rinse

This helps to increase the amount

of rinse cycles in programmes for

cottons fabrics. We recommend

that you use it to improve the

machine's rinsing power when

dealing with a full load and a

great amount of detergent.

Rapid wash

This button reduces the length of

the wash programme by about

30%. It cannot be used with

special programmes (see page 4)

or those for wool and silk.

On-off

When button H is pressed, the

washing machine is switched on,

when it is not the machine is

switched off.

Turning the appliance off does

not cancel the selected

programme.

Here Im in command

Understanding the control panel

Making the right choice is important. And its easy.

Margheritas knobs are hidden. Just

press them lightly in the middle to

extract them.

Programme selector knob

and programmed start

Use this knob to select the wash

programme.

Turn this knob clockwise only.

To select a programme, you

should turn the knob so that the

symbol/number of the desired

programme is in line with the

pointer on the glass M.

Now press on/off button H

(position ON), pilot lamp I will

start flashing.

After 5", the setting will be

accepted, pilot lamp I will stop

flashing (staying lit) and the wash

cycle will begin.

Should you wish to interrupt the

programme in progress or set a

new one, select one of the

symbols

(Stop/Reset) and wait

5" : when the cancellation has

been accepted, pilot lamp I

flashes, and you can then turn the

appliance off.

You can use this knob to delay

the appliance's operation.

Select one of the four delay time

positions, press the on/off button

H (position ON) and wait 5". The

setting has now been accepted

(pilot lamp I stays lit) and you

can select the programme you

desire.

Pilot lamp I has a particular

flashing motion (2" on and 4"

off) to indicate that a delayed

start has been set.

During this phase, you can open

the appliance door and change

the washing load, should you

wish to do so.

After the wash cycle has been set

and accepted by the washing

machine, turning the knob will

have no effect (except for when

it is on position Stop/Reset).

Temperature control knob

It is used to set the wash tempe-

rature in the recommended

programme table on pag. 4. It also

allows you to reduce the tempe-

rature recommended for the

selected programme, and even to

set a cold wash cycle ( ).

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-wash;

2. Detergent for the main cycle

wash;

3. Fabric conditioner.

Rinse hold

This button allows you to

interrupt a programme (on

symbol ) keeping the washing

soaking in water before the spin

cycle. It is a very useful button

in particular because it can be

used for delicates and synthetics.

It is only to be used with wash

program-mes for synthetic

fabrics, silk and curtains when it

is impossible for you to take the

washing out immediately. Before

opening the washing machine

door, finish the wash cycle as

follows:

The detergent dispenser is here.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston al 109 x Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info