313577
4
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
M
ARGHERITA
Margherita - Instructions for installation and use
I
G
L
F
E
H
N
M O
A
B
C
D
Rapid wash
This button reduces the length of
the wash programme by about
30%. It cannot be used with
special programmes (see page 4)
or those for wool and silk.
Prewash
With this button, you can pre-
wash on all programmes except
the wool programme and the
special programmes (see page 4).
On-off
When button L is pressed, the
washing machine is switched on,
when it is not the machine is
switched off.
Turning the appliance off does
not cancel the selected
programme.
The on-off lamp
Lamp M flashes when the
appliance is switched on and
awaiting a programme to be set.
A steady light means the
appliance has accepted the
selected programme.
The door block lamp
The safety lamp indicates that the
washing machine door is locked
to prevent it from being opened
accidentally. To avoid any
damages to lock mechanism, you
must wait for the lamp to
extinguish, before attempting to
open the door which takes
around three minutes.
Programme key
This contains the descriptions of the
wash programmes and the various
functions connected to the buttons.
Pull it outwards to open it.
Rinse hold
This button allows you to
interrupt a programme (on
symbol ) keeping the washing
soaking in water before the spin
cycle. It is a very useful button
in particular because it can be
used for delicates and synthetics.
It is only to be used with wash
program-mes for synthetic
fabrics, silk and curtains when it
is impossible for you to take the
washing out immediately. Before
opening the washing machine
door, finish the wash cycle as
follows:
Silk and curtains: press button
F and Margherita will drain the
water.
Synthetic fabrics: press button F
if you want a spin cycle, or turn
knob A to symbol if you
want the water to be drained.
With "Daily wash" or "Hand
wash", this function is not
enabled.
Extra Rinse
This helps to increase the amount
of rinse cycles in programmes for
cotton fabrics. We recommend
that you use it to improve the
machine's rinsing power when
dealing with a full load and a
great amount of detergent.
Here Im in command
Understanding the control panel
Making the right choice is important. And its easy.
Margheritas knobs are hidden. Just
press them lightly in the middle to
extract them.
Programme selector knob
and programmed start
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the glass O.
Now press on/off button L
(position ON), pilot lamp M will
start flashing.
After 5", the setting will be
accepted, pilot lamp M will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp M
flashes, and you can then turn the
appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the four delay time
positions, press the on/off button
L (position ON) and wait 5". The
setting has now been accepted
(pilot lamp M stays lit) and you
can select the programme you
desire.
Pilot lamp M has a particular
flashing motion (2" on and 4"
off) to indicate that a delayed
start has been set.
During this phase, you can open
the appliance door and change
the washing load, should you
wish to do so.
After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position Stop/Reset).
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 4. It also
allows you to reduce the tempe-
rature recommended for the
selected programme, and even to
set a cold wash cycle ( ).
Spin regulation knob
It is used to exclude the spin
cycle (by choosing symbol
) or
to reduce the spin speed of the
selected programme. The
maximum speed for the four
types of fabric are:
Fabric Speed
Cotton 1600 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
Note: distribution phase will be
carried out at low speed.
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
The detergent dispenser is here.
3
1
2
3
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hotpoint-Ariston al 169 x wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info