Bedienungsanleitung Hotpoint-Ariston BDC M45 V IX S HA (Seite 15 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

510934

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Using the refrigerator to its full

potential

 Use the TEMPERATURE ADJUSTMENT knob to

adjust the temperature (see Description).

 Place only cold or lukewarm foods in the

compartment, not hot foods (see Precautions and

tips).

 Remember that cooked foods do not last longer than

raw foods.

 Do not store liquids in open containers. They will

increase humidity in the refrigerator and cause

condensation to form.

Using the freezer to its full potential

 Do not re-freeze food that is defrosting or that has

already been defrosted. These foods must be cooked

and eaten (within 24 hours).

 Fresh food that needs to be frozen must not come

into contact with food that has already been

defrosted. Fresh food must be stored above the grill in

the freezer compartment and if possible be in direct

contact with the walls (side and rear), where the

temperature drops below -18°C and guarantees rapid

freezing.

 Do not place glass bottles which contain liquids, and

which are corked or hermetically sealed in the freezer

because they could break.

 The maximum quantity of food that may be frozen daily

is indicated on the plate containing the technical

properties located on the bottom left side of the

refrigerator compartment (for example: Kg/24h: 4)

! Do not open the door during freezing.

! If there is a power cut or malfunction, do not open the

freezer door. This will help maintain the temperature

inside the freezer, ensuring that foods are conserved for

at least 9 -14 hours.

! If the room temperature drops below 14°C for an

extended period of time, the ideal temperature will not

be reached in the freezer compartment and food

preservation will be reduced.

EASY ICE ice tray

The Easy Ice trays are set into the freezer door to

maximise the space within the freezer. The trays are

drip-free and sealed to prevent food from tainting the ice

cubes.

1. Pull out the tray by pushing it

up and then outwards (see

diagram).

Check that the tray is ompletely

empty and fill it with water

through the opening provided.

2. Take care not to exceed the

level indicated (MAX WATER

LEVEL). Excess water prevents

the ice cubes from dispensing (if

this happens, wait for the ice to

melt and empty the tray).

3. Turn the tray 90°: due to the

connected compartments each

mould fills with water (see

diagram).

4. Close the opening with the lid provided and put the

tray back, placing the top part in the corresponding

housing and allowing it to drop in again.

5. When the ice has formed (minimum time

approximately 8 hours) knock the tray against a hard

surface and wet the outside so that the ice cubes come

loose and take them out through the opening.

MAX

WATER LEVEL

MAX

WATER LEVEL

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston BDC M45 V IX S HA Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info