Bedienungsanleitung Hotpoint-Ariston FH 53IX (Seite 21 von 72) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

468887

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

 The stainless-steel or enamel-coated external parts

as well as the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. If these stains are difficult to

remove, use only specialised products. After

cleaning, rinse and dry thoroughly. Do not use

abrasive powders or corrosive substances.

 Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft cloth.

Do not use abrasive products.

 All accessories - with the exception of the sliding

racks - can be washed like everyday crockery, and

are even dishwasher safe.

 Never use steam cleaners or pressure cleaners on

the appliance.

Cleanin g the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack. To

clean more thoroughly, you can remove the oven door.

1. Open the oven door fully (see diagram).

2. Lift up and turn the small levers located on the

two hinges (see diagram).

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps F, then pull the door

towards you lifting it out of its

seat (see diagram).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

Wattage 25 W,

cap E 14.

3. Replace the

glass cover (see

diagram).

Sliding Rack Kit assembly

To assemble the sliding racks:

1. Loosen the two

screws A (see diagram).

If the oven is fitted with

self-cleaning panels,

these will have to be

temporarily

disassembled.

2. Replace the screws A with the screws and

spacers (B + C) supplied with the kit.

3. Tighten the new screws B and the corresponding

spacers C, fitting the self-cleaning panels on

again.

4. Secure the two joints

D of the guide rail in the

holes provided on the

oven walls (see

diagram). The holes for

the left guide rail are

situated at the top, while

the holes for the right

one are at the bottom.

5. Finally, fit the guide rail on the spacer C.

 Do not place the sliding racks in position 5.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston FH 53IX Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info