Bedienungsanleitung Hotpoint-Ariston LD 6090 EU (Seite 19 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

513353

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Start-up and use

* Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

2. Press the STANDBY button: the display will light up.

3. Open the door and pour in a suitable amount of

detergent (

see below

4. Load the racks (

see Loading the racks

) and shut

the door.

5. Select a wash cycle by pressing the SELECT

WASH CYCLE button repeatedly until the number

corresponding to the desired cycle appears (

see

Table of Wash Cycles

6. Select the wash options (

see below

7. Start the cycle by pressing the START/RESET

button: the machine will emit a confirmation beep.

The WASH CYCLE PHASE indicator lights display

the status of the cycle:

Pre-wash, Wash, Rinse, or Drying.

8. At the end of the wash cycle, you will hear two

short beeps and the word “END” will appear on the

display.

9. Switch off the appliance by pressing the

STANDBY button, shut off the water tap and unplug

the appliance from the electricity socket.

10. Open the door and wait for a few minutes before

removing the crockery inside, in order to avoid burns.

Unload the racks, beginning with the lower level.

Demo*

If dON appears on the display, this means that the

appliance is in demonstration mode. To deactivate

it, press the START/RESET and STANDBY buttons

simultaneously: dOF should appear on the display.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided

that it has only just begun: press and hold the START/

RESET button for 4 seconds. After one long beep and

three short beeps, the WASH CYCLE PHASE indicator

light will switch off: Select the new cycle and switch the

machine back on by pressing the START/RESET button.

Adding extra crockery

Press the STANDBY button and open the door,

taking care to avoid the escaping steam, and place

the crockery inside the dishwasher. Press the

STANDBY button again: the cycle starts from the

point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle (the text

DOOR will appear on the display), or if there is a

power cut, the cycle stops. It starts again from the

point at which it was interrupted once the door has

been shut or the electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct

amount of detergent being used, as recommended

by the manufacturer. Exceeding the recommended

amount does not result in a more effective wash and

pollutes the environment.

compartment A: Washing detergent

compartment B: Pre-wash detergent

1. Open cover C by

pressing button D.

2. Pour in the detergent

after consulting the

Wash

cycle table

• for powder detergent

use compartments A

and B

• for tablets, use

compartment A and the

bottom of the appliance,

i.e. when the cycle

requires 1 tablet, place it in compartment A and

close the cover; when it requires 2, place the

second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston LD 6090 EU Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info