Bedienungsanleitung Hotpoint-Ariston LF 6070 (Seite 18 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch)

71558

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Starting the dishwasher

1. Turn on the water tap.

2. Press the STANDBY button: the display will light up.

3. Open the door and pour in a suitable amount of detergent

(

see below

4. Load the racks (

see Loading the racks

) and shut the door.

5. Select a wash cycle by pressing the SELECT WASH CYCLE

button repeatedly until the number corresponding to the cycle

required appears.

6. Select the wash options (

see below

7. Start the cycle by pressing the START/RESET button: the

machine will emit a confirmation beep. The WASH CYCLE

PHASE indicator lights display the status of the cycle: Pre-

wash, Wash, Rinse, or Drying.

8. At the end of the cycle three short beeps will sound and

END will appear on the display. Switch off the appliance by

pressing the STANDBY button and turn off the water tap.

9. Open the door and wait for a few minutes before removing

the crockery, in order to avoid burns. Unload the racks,

beginning with the lower level.

Demo*

If dON appears on the display, this means that the appliance

is in demonstration mode. To deactivate it, press the START/

RESET and STANDBY buttons simultaneously: dOF should

appear on the display.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: press and hold the START/RESET button for 4

seconds. After one long beep and three short beeps, the

WASH CYCLE PHASE indicator light will switch off. Select the

new cycle and switch the machine back on by pressing the

START/RESET button.

Adding extra crockery

Press the STANDBY button and open the door, taking care to

avoid the escaping steam, and place the crockery inside the

dishwasher. Press the STANDBY button again: the cycle

starts from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct amount of

detergent being used, as recommended by the manufacturer.

Exceeding the recommended amount does not result in a

more effective wash and pollutes the environment.

compartment Acompartment A

compartment A: Washing detergent

compartment Bcompartment B

compartment B: Pre-wash detergent

1. Open cover C by pressing

button D.

2. Pour in the detergent after

consulting the

Wash cycle

table

• for powder detergent use

compartments A and B

• for tablets, use

compartment A and the

bottom of the appliance, i.e.

when the cycle requires 1

tablet, place it in compartment A and close the cover;

when it requires 2, place the second tablet at the bottom of

the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle for a period of

time between 1 and 24 hours.

1. Press the DELAYED START button: every time the button is

pressed, the time selected appears on the display and the

delayed start indicator light illuminates.

2. Select the wash cycle and press the START/RESET button:

after the beep sounds, the timer begins counting down.

3.Once this time is up, the indicator light switches off and the

wash cycle begins.

To adjust the delay time and select a lower period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the wash cycle begins and the WASH

CYCLE PHASE indicator light corresponding to the start of the

cycle in progress illuminates.

Half load using the upper rack

If there are not many dishes to be washed, a half load cycle

may be used in order to save water, energy and detergent.

Before selecting the wash cycle press the HALF LOAD button:

the indicator light will illuminate and the wash cycle will take

place only in the upper rack.

Remember to load the upper rack only, and to reduce the

amount of detergent accordingly.

 It is better to use powder detergent in this case.

 This button cannot be used with the quick wash or baby

care cycles.

All-in-one tablets button*

When using multi-use tablets (2-in-1, 3-in-1, 4-in-1 etc.), press

the ALL-IN-ONE TABLETS button. This option optimises the

results of the wash. The overall duration of the programme

increases by approximately 10 minutes.

This option is not recommended for use with wash cycles

which do not specify the use of multi-use tablets (

see table of

wash cycles

Start-up and use

* Only available in selected models.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston LF 6070 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info