Bedienungsanleitung Hotpoint-Ariston li 485 a c ha (Seite 18 von 84) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

127564

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

&

Starting the dishwasher

1. Turn the water tap on.

2. Open the door and press the ON/OFF button: the indicator

light will illuminate.

3. Measure out the detergent (see below).

4. Load the racks (see Loading the racks).

5. Select the programme by pressing the WASH CYCLE

SELECT button; the corresponding indicator light will illuminate.

6. Select the wash options* (see below).

7. Start the wash cycle by shutting the door: the machine will

emit a confirmation beep.

8. At the end of the cycle two short beeps will sound and the

WASH CYCLE indicator light will flash. Open the door, switch

off the appliance by pressing the ON/OFF button, shut off the

water tap and unplug the appliance from the electricity socket.

9. Wait for a few minutes before removing the crockery, in

order to avoid burns. Unload the racks, beginning with the

lower level.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun: open the door, taking care to avoid the

escaping steam, and press the WASH CYCLE SELECT

button, holding it for 4 seconds. After one long beep and three

short beeps, the WASH CYCLE indicator light will switch off:

select the new wash cycle and start the programme by

shutting the door.

Adding extra crockery

Open the door, taking care to avoid the escaping steam, and

place the crockery inside the dishwasher. Close the door: the

cycle starts from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A good wash result also depends on the correct

amount of detergent being used; exceeding the

stated amount does not result in a more effective

wash and increases environmental pollution.

Only use detergent which has been

specifically designed for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam

residue remaining in the machine after the cycle

has ended.

The use of tablets is only recommended for

models which offer the MULTI-FUNCTIONAL

TABLETS option.

To achieve the best results from each

washing and drying cycle, powder detergent,

rinse aid liquid and salt should be used.

compartment A: Washing detergent

compartment B: Pre-wash detergent

1. Open cover C by pressing button

2. Pour in the detergent after

consulting the Wash cycle table:

 for powder detergent use

compartments A and B

 for tablets, when the cycle requires

1 tablet, place it in compartment A and

close the cover; when it requires 2, place the second tablet at

the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle by 2, 4 or 6

hours.

1. Press the DELAYED START button: every time the button is

pressed, a beep is emitted and the selected delayed start

indicator light illuminates.

2. Select the wash cycle and shut the door: after the beep

sounds, the timer begins counting down.

3. Once this time has elapsed, the indicator light switches off

and the wash cycle begins.

To adjust the delay time and select a smaller period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the selected delayed start indicator

light switches off. The wash cycle will start automatically as

soon as the door is shut.

Start-up and use

* Only available in selected models.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston li 485 a c ha Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info