Bedienungsanleitung Hotpoint-Ariston LI 671 A (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

75130

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

You have loaded your dishes and you now have to set the

wash cycle. It takes just one minute to learn how

Starting the dishwasher

Ready, steady, go!

You can cancel the

wash cycle in

progress, if it has

only just started.

Make sure the wash

cycle has ended

before removing the

dishes!

If opening the door

soon after the end of

the programme,or

during it, stand away

from the Dishwasher,

to avoid possible

injury from hot

steam.

Do you want extra

drying?

Press button "E" before you

start the selected wash cycle.

A prolonged beep will inform

you that you have selected ex-

tra drying, a short beep

indicates it has been disabled.

With extra drying, the wash

cycle will last longer, to provide

you with drier dishes.

First of all.

After performing all the operations

described in the previous para-

graphs, turn the water tap on com-

pletely, open the appliance door and

press ON-OFF button "A": indica-

tor light "B" comes on. Your appli-

ance is now on and awaiting instruc-

tions.

Selecting the wash

cycle.

Select the wash cycle by pressing

button "P". Each time this button

is pressed, one of the indicator

lights "M" will come on in sequence,

select the wash cycle you deem

most suitable for the type of dishes

to wash (take a look at page 17,

where you will find the wash cycle

table). Close the appliance door and

after a few seconds, you will hear

a short beep: the wash cycle has

begun.

Modifying a wash cycle in

progress.

But if you have chosen the wrong

cycle, not to worry! You can modify

the wash cycle in progress, if it has

only just started. Open the appli-

ance door carefully to avoid any

hot water splashes, then keep but-

ton "P" pressed for approximately

5 seconds, until you hear 3 short

beeps. Indicator light "M" will come

off and at this point, all the settings

will have been cancelled. You are

now free to re-set the correct wash

cycle.

You've left out a dish?

Well, it happens to everyone. Inter-

rupt the wash cycle by opening the

appliance door with the utmost

care, as usual, then insert the dish

you had forgotten. When you shut

the appliance door, the cycle will

start up from where you interrupted

it.

Finished?

The end of the wash cycle is indi-

cated by a double beep and the

flashing of the wash cycle indicator

light "M".

Turn off the water tap.

Wait a few minutes before unload-

ing the dishes: they are very hot! If

you wait a little while, they dry

better thanks to the steam.

Empty the lower rack first.

There's been a power

failure? Have you

opened the dishwasher

door?

The wash cycle stops and then

restarts when the electricity comes

back on or when you close the door.

Everything is under control!

Warning!

Open the dishwasher door,

turn off by pressing button A,

unplug the appliance from the

electricity socket to cut off the

power supply; the power supply

cable should consequently be

easily accessible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston LI 671 A Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info