Bedienungsanleitung Hotpoint-Ariston LI 700 I-S (Seite 7 von 36) (Englisch, Französisch, Spanisch)

512318

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ARISTON DISHWASHER - User Manual 5

www.aristonappliances.us

You have loaded your dishes and you now have to set

the wash cycle. It takes just one minute to learn how

Starting the dishwasher

Ready, steady, go!

You can cancel the

wash cycle in progress,

if it has only just started.

Make sure the wash

cycle has ended before

removing the dishes!

Selecting the wash cycle.

Select the wash cycle by

pressing button "P". Each

time this button is pressed,

one of the indicator lights

"M" will come on in

sequence, select the wash

cycle you deem most

suitable for the type of

dishes to wash (take a look

at page 7, where you will

find the wash cycle table).

Close the appliance door

and after a few seconds,

you will hear a short beep:

the wash cycle has begun.

Modifying a wash cycle in

progress.

If you have chosen the

wrong cycle, not to worry!

You can modify the wash

cycle in progress, if it has

only just started. Open

the appliance door

carefully to avoid any hot

water splashes, then

keep button "P" pressed

for approximately 5

seconds, until you hear a

short beep. Indicator light

"M" will come off and at

this point, all the settings

will have been cancelled.

You are now free to re-set

the correct wash cycle.

You've left out a dish?

Well, it happens to

everyone. Interrupt the

wash cycle by opening the

appliance door with the

utmost care, as usual,

then insert the dish you

had forgotten. When you

shut the appliance door,

the cycle will start up from

where you interrupted it.

Finished?

The end of the wash cycle

is indicated by a double

beep and the flashing of the

wash cycle indicator light

"M". Open the dishwasher

door, press the ON-OFF

button as well, thus cutting

off the electricity supply to

the appliance.

If accessible turn off the

water tap.

Wait a few minutes before

unloading the dishes: they

are very hot! If you wait a

little while, they dry better

thanks to the steam.

Empty the lower rack

first.

There's been a power

failure? Have you opened

the dishwasher door?

The wash cycle stops and

then restarts when the

electricity comes back on

or when you shut the door.

Everything is under control!

Do you want extra drying?

Press button "E" before

you start the selected

wash cycle. A long beep will

tell you that you have

selected extra drying and

the wash cycle will last

longer in order to provide

you with drier dishes.

After performing all the

operations described in the

previous paragraphs, if

accessible turn the water

tap on, open the appliance

door and press on-off

button "A": indicator light

"B" comes on.

Your appliance is now on

and awaiting instructions.

If opening the

door soon

after the end

of the program, or

during it, stand away

from the Dishwasher,

to avoid possible

injury from hot steam.

You decide when it starts.

When you have loaded the

dishes, you can choose

when to start your

dishwasher before setting

the desired wash cycle.

Press button "C" to delay

the start of the wash cycle

by 2, 4 or 6 hours. Each

time you press it, you will

hear a short beep and

indicator light "D"

corresponding to the

selected delay will come

on.

Now you can select the

desired wash cycle. Close

the appliance door and,

after you hear the beep,

the countdown to the

delayed start will begin.

Once this time is up, the

indicator light will stop

flashing and the wash

cycle will begin.

If you change your mind

and you wish to set a

different delay, just open

the appliance door, press

button "C" and repeat the

selection.

If, on the other hand, you

want to cancel the delayed

start set and you want the

wash cycle to start

immediately, press the

button repeatedly until

indicator light "D" comes

off. Once you close the

door, the wash cycle set

previously will begin.

You want to wash on the

upper rack only?

Remember to use half the

amount of detergent.

Your dishwasher also

allows you to wash half a

load, to save water and

electricity.

Before setting any wash

cycle whatsoever, press

button Q to select that

you want to run a half cycle

on the upper rack.

When you press it, you will

hear a beep and indicator

light R corresponding to

the selected function will

come on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston LI 700 I-S Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info