Bedienungsanleitung Hotpoint-Ariston LL 6066 (Seite 6 von 36) (Englisch, Portugiesisch, Spanisch)

512976

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Starting the dishwasher

1. Open the water inlet valve.

2. Press the ON/OFF button: the machine will emit a beep and

the ON/OFF indicator light will illuminate.

3. Open the door and measure out a suitable amount of

detergent

(see below)

4. Load the racks

(see Loading the racks)

and shut the door.

5. Select the wash cycle by pressing the SELECT WASH

CYCLE button: the corresponding indicator light will illuminate.

6. Select the wash options

(see below)

7. Start the cycle by pressing the START/RESET button: the

machine will emit a confirmation beep. The WASH CYCLE

PHASE indicator lights display the status of the cycle:

Pre-wash, Wash, Rinse, or Drying.

8. At the end of the cycle two short beeps will sound and the

DRYING indicator light will flash. Switch off the appliance by

pressing the ON/OFF button and close the water inlet valve.

9. Open the door and wait for a few minutes before removing

the crockery inside, in order to avoid burns. Unload the racks,

beginning with the lower level.

Modifying the duration of a wash cycle already in

progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided that it has

only just begun:press and hold the START/RESET button for 5

seconds After one long beep and three short beeps, the

WASH CYCLE PHASE indicator light will switch off: select the

new cycle and switch the machine back on by pressing the

START/RESET button.

Recap Settings

Press the SELECT WASH CYCLE button:

The indicator light corresponding to the wash cycle selected

will illuminate, followed by the HALF LOAD* indicator light or the

ALL-IN-ONE TABLETS* indicator light (if these options have

been selected).

Adding extra crockery

Press the ON/OFF button and open the door, taking care to

avoid the escaping steam, and place the crockery inside the

dishwasher. Press the ON/OFF button again: the cycle starts

from the point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle, or if there is a

power cut, the cycle stops. It starts again from the point at

which it was interrupted once the door has been shut or the

electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct amount of

detergent being used, as recommended by the manufacturer.

Exceeding the recommended amount does not result in a

more effective wash and pollutes the environment.

Only use detergent which has beenOnly use detergent which has been

Only use detergent which has been

specifically designed for dishwashers.specifically designed for dishwashers.

specifically designed for dishwashers.

DO NOT USE washing up liquid. DO NOT USE washing up liquid.

DO NOT USE washing up liquid.

To obtain the best results from each washing and drying

cycle, powder detergent, rinse aid liquid and salt should be

used.

compartment Acompartment A

compartment A: Washing detergent

compartment Bcompartment B

compartment B: Pre-wash detergent

1. Open cover C by pressing button

2. Pour in the detergent after

consulting the

Wash cycle table

• for powder detergent use

compartments A and B

• For detergent in tablet form: when

the cycle requires 1 tablet, place it in

compartment A and close the cover;

when it requires 2, place the second

tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Washing options

Delayed start

It is possible to delay the start time of the cycle by 12, 9, 6 or 3

hours.

1. Press the DELAYED START button: every time the button is

pressed, a beep is emitted and the selected delayed start

indicator light illuminates.

2. Select the wash cycle and press the START/RESET button:

after the beep sounds, the timer begins counting down.

3. Once this time has elapsed, the indicator light switches off

and the wash cycle begins.

To adjust the delay time and select a smaller period of time,

press the DELAYED START button. To cancel it, press the

button repeatedly until the wash cycle begins and the WASH

CYCLE PHASE indicator light corresponding to the start of the

cycle in progress illuminates.

All-in-one tablets*

When using multi-use tablets press the ALL-IN-ONE TABLETS

button. This option optimises the results of the wash. The

overall duration of the programme increases by approximately

10 minutes.

This option is not recommended for use with wash cycles

which do not specify the use of multi-use tablets (

see table of

wash cycles

Start-up and use

* Only available in selected models.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston LL 6066 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info