76247

Hotpoint-Ariston LV 460 IX Seite 21

21
Zoom out
Zoom in
Vorherige Seite
1/80
Nächste Seite
ARISTON DISHWASHER - Instructions for installation and use
19
D
ISHWASHER
If the power socket to
which the appliance is
connected is not
compatible with the
plug, replace it with a
suitable plug rather
than using adapters or
multiple plugs as these
could cause
overheating or burns.
Installation and moving
After having bought or moved your dishwasher to another home, a
correct installation ensures that your dishwasher will operate
smoothly and efficiently.
Your dishwasher has arrived
Anti-flooding protection
Your dishwasher (model LV 460A)
is provided with a special system
which blocks the water supply in
the event of leaks inside the appli-
ance. It is further equipped with a
water inlet hose (WATER STOP)
that can withstand extremely high
pressures and that turns bright red
in the event of breakage. Safety in
the event of flooding is ensured by
the second clear hose that contains
the former and thus highlights the
latter when it has turned bright red.
It is vital that you check it on a
regular basis: if you see it has turned
bright red, then you know you have
to replace it as soon as possible.
Call for an authorised technical
engineer to come and replace it.
Drain hose connection.
Fit the drain pipe into a drain line
with a minimum diameter of 4 cm
or place it over the sink. Avoid
restricting or bending it. The part
of the pipe marked with the letter
A should be between 40 and 100
cm above the ground.
The pipe should not be immersed
in water.
Choose where you want to install
your dishwasher, you can even
place it so that its sides or back
panel are side by side with furniture
or up against the wall. The
dishwasher is provided with water
supply and drain hoses, which can
be directed towards the left or right
to facilitate appropriate
installation.
Levelling.
Once the appliance is positioned,
adjust the feet by screwing them
in or out depending on how high
you want it and to level it so that it
is horizontal. Make sure that it is
not inclined more than 2 degrees.
If the appliance is level, it will he
lp ensure its correct operation.
Adjusting the Back Feet
Insert the appliance into the cutout
and then adjust the height using
the screws located on the front
bottom part of the machine. Use a
screwdriver to turn the screws in
the clockwise or anti-clockwise
direction to increase or decrease
the height respectively.
Cold water connection.
Connect the cold water supply
hose to a threaded 3/4 (gas)
connector, and making sure that
it is fastened tightly in place.
The LV460 A model, have a "Water
Stop" water supply pipe.
If the water pipes are new or have
not been used for an extended
period of time, let the water run to
make sure that the water is clear
and free of impurities. If this
precaution is not taken, there is a
risk that the water inlet can get
blocked and damage the appliance.
Hot water connection.
Your dishwasher can be supplied
with hot water from the mains
supply (if you have a central
heating system with radiators) at
a temperature of no more than
60°C.
In this case, the wash cycle time
will be about 15 minutes shorter
and the wash will be slightly less
effective.
The connection must be made to
hot water supply following the
same procedures as those indicated
for the cold water connection.
Electrical connection.
First of all, check that the mains
voltage and frequency values
correspond to those stated on the
rating plate located on the stainless
steel inner door of the appliance
and that the electrical system to
which the dishwasher is connected
is sized for the maximum current
indicated on said rating plate.
Power supply wire.
Check the power supply wire on a
regular basis; if it is damaged, we
recommend you have it replaced
by an authorised technical
Assistance service centre.
Condensation-proof tape.
On some models, a transparent
condensation-proof adhesive tape
has been provided.
It should be stuck onto the lower
side of your wooden worktop to
protect it from the formation of
condensation.
When not provided, this tape can
be requested as a spare part from
authorised retailers.
A
Earth: indispensable
safety.
Only now can you plug the
appliance into a socket provided
with an efficient earth connection
(the system's earthing is a
guarantee of safety provided for
by law, make sure your system has
it).
The plug
The dishwasher plug must be
accessible even when the appliance
is installed as a built-in unit so that
maintenance can be done safely.
… 21 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

hotpoint-ariston-lv-460-ix

Suche zurücksetzen

  • Nach dem Einschalten Entstehen Kochgeräusche, gegen Ende des Waschvorganges blinken die erste und die dritte LED und das Spülwasser wird nicht abgepumpt Eingereicht am 17-12-2018 14:04

    Antworten Frage melden

  • Kann mir jemand helfen? Jedes mal wenn wir den Geschirrspüler anschalten fliegt der FI raus? Eingereicht am 22-7-2018 19:43

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hotpoint-Ariston LV 460 IX wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info