Bedienungsanleitung Hotpoint-Ariston lv 620 bk (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

126826

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ARISTON DISHWASHER - Instructions for installation and use

ISHWASHER

You have loaded your dishes and you now have to set the

wash cycle. It takes just one minute to learn how

Starting the dishwasher

Ready, steady, go!

You can cancel the

wash cycle in

progress, if it has

only just started.

Make sure the wash

cycle has ended

before removing the

dishes!

If opening the door

soon after the end of

the programme,or

during it, stand away

from the Dishwasher,

to avoid possible

injury from hot

steam.

First of all.

After performing all the

operations described in the

previous paragraphs, turn the

water tap on completely and

press ON-OFF button "A": you

will hear a short beep and

indicator light "B" lights up.

Now the appliance is on and

ready to be programmed.

Selecting the wash

cycle.

To select the wash cycle, turn

knob "D" clockwise until the

reference notch on the knob

corresponds with the number

or symbol for the cycle you

wish to set (have a look at the

wash cycle table on page 17).

A short beep will indicate the

start of the wash cycle and

indicator light "G"

corresponding to the cycle

starting phase will light up.

The dishwasher keeps

you informed.

Your dishwasher is fitted with

indicator lights (G) which light

up to indicate the cycle phase

under way.

Here are the symbols corre-

sponding to each cycle phase:

pre-wash, wash, rinses, drying.

At all times, your dishwasher

tells you which cycle phase is

under way.

Modifying a wash cycle

in progress.

But if you have chosen the

wrong cycle, not to worry! You

can modify the wash cycle in

progress, if it has only just

started. Turn the knob anti-

clockwise until it reaches the

Reset position and, after a few

seconds, you will hear 4 beeps

and indicator light "G" will turn

off. This is to inform you that

all the settings have been can-

celled. You are now free to re-

set the correct wash cycle.

You've left out a dish?

Well, it happens to everyone.

Interrupt the wash cycle by

pressing the ON-OFF button,

insert the dish you had forgot-

ten and press the ON-OFF but-

ton again. The cycle will start

up from where you interrupted

it.

Finished?

The end of the wash cycle is

indicated by two short beeps

and the flashing of the drying

phase indicator light.

Turn the knob anti-clockwise to

Reset in order to reset all the

settings.

Turn the appliance off to cut off

the electricity supply.

Turn off the water tap.

Wait a few minutes before un-

loading the dishes: they are very

hot! If you wait a little while,

they dry better thanks to the

steam.

Empty the lower rack first.

There's been a power

failure? Have you

opened the dishwasher

door?

The wash cycle stops and then

restarts when the electricity

comes back on or when you

shut the door. Everything is

under control!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston lv 620 bk Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info