Bedienungsanleitung Hotpoint-Ariston TCD751 (Seite 11 von 88) (Englisch, Französisch, Portugiesisch, Spanisch)

490146

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

Start and Programmes

Timed Drying

Timed programmes table: First select a programme (see Programmes Table).

(0:20, 0:40,

1:00, 1:20, 1:40,

2:00 or 2:20

Hours:Minutes)

Always use Timed Drying

for loads less than 1kg, or

if you prefer a different

dryness result.

The heat setting depends

on the programme

(material option) selected.

Consult suggested drying

times (see Laundry).

The last 10 minutes of these

programmes is the Cool

Tumble phase .

1. Press and release the Timed button

until the display shows the required

selection. Each press advances ,

, , , , , then and

then repeats.

●

Delicates have maximum time of .

●

When is displayed, Automatic

option is available if you change your

mind.

2. Select any Options if required.

3. Press the Start button .

Options available:

Alarm , Time Delay ,

Pre Care , Post Care .

! Warning, after pressing the Start/Pause button ,

the programme cannot be changed.

To change a selected programme, press the

Start/Pause button , the light flashes Amber to

indicate the programme is paused. Select the new

programme and any options required, the light will

then flash green. Press the Start/Pause button

again and the new programme will start.

●

Option buttons / icons

These buttons are used to customise the selected

programme to your requirements. A programme must

have been selected, by pressing a programme selection

button, before an option can be selected. Not all

options are available for all programmes (see

Programmes Table). If an option is not available and

you press the button, the buzzer will beep 3 times. If

the option is available the indicator, on the display unit

next to the bottom buttons, lights to show that the

option has been selected.

Time Delay

The start of some programmes (see The Display and

Start and Programmes) can be delayed for up to 24

hours. Ensure the water container is emptied before

setting a delayed start.

Pre Care

This option is only available if a delayed start has

been selected. It tumbles the clothes occasionally

during the delayed period to help prevent creases

developing.

Alarm

Available on all programmes and allows the buzzer to

give a signal at the end of the drying cycle, to remind

you that the clothes are ready to be removed.

Post Care

When available and selected, the clothes are

occasionally tumbled after the end of the drying and

cool tumble cycles, to help prevent creases

developing should you not be available to remove the

load immediately the programme is complete.

●

TIME DISPLAY

The display shows either the amount of time delay

remaining or an indication of the amount of time left for

a drying programme (see The Display).

The delay or time to end is displayed in hours and

minutes and counts down each minute.

When timed programmes are selected the time

displayed throughout the cycle is the actual time

The Controls

88:88

remaining.

When an Automatic programme is selected, the time

displayed is an estimate of the time remaining. When

the programme is selected the display shows the time

required to dry a full load, after around 10 minutes the

controller calculates a better estimate of the cycle time.

The colons between the hours and minutes in the

display flash to show that the time is counting down.

The display also shows if there is a problem with your

dryer, if this occurs the display will show F followed by

a fault code number (see Troubleshooting).

●

Empty Water Container

(If you have plumbed your dryer to a drain this icon can

be ignored, as there is no need to empty the water

container).

Messages are displayed to reminds you to empty the

water container.

If the water container fills during a programme, the

heater turns off and the dryer does a period of Cool

Tumble. After this it stops and a message tells you to

EMPTY THE WATER CONTAINER .

You must empty the water container and restart the

dryer or the clothes will not dry. After re-starting the

dryer the message will take a few seconds to go out.

To avoid this always empty the water container each

time you use the dryer (see Maintenance).

●

Door Opening

Opening the door during a programme will stop the

dryer and have the following effects:

●

The display shows PAUSED .

●

During a delay phase the delay will continue to

count down. The Start/Pause button must be

pressed to resume the delay programme.

The display will change to show current status.

●

During the drying part of the programme, the

colons on the display stop flashing to show that

the time has stopped counting down.

The Start/Pause button must be pressed to

resume the programme. The display will change to

show the current status, the colons flash and count

down continues.

●

During the Post Care phase, the programme ends.

Pressing the Start/Pause button will restart a new

programme from the beginning.

●

Note

If you have a power cut, switch off the power or

remove the plug. When power is restored, press the

Start/Pause button and the programme will resume.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint-Ariston TCD751 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info