Programme selection
The most appropriate programme can be
identified by comparing the type of crockery,
cutlery etc., as well as the amount and
condition of food remains,with the details
contained in the programme overview.
The corresponding programme sequence,
duration and consumption details are shown
in the bottom half of the overview.
For example:
Use the “Normal”programme for dishes and
utensils which have plenty of food remains
stuck on hard.
Reduce costs
If only a small number of dishes have been
loaded into the dishwasher, selecting a
programme that operates at the next lowest
temperature will usually suffice.
Programme data
The stated programme data are based on
standard operating conditions.The values can
vary considerably according to:
- Different amounts of dishes
- Temperature of mains water supply.
- Pressure of mains water supply
- Ambient temperature
- Fluctuations in mains voltage.
- Machine-related factors (e.g.
temperature,water volume,...)
Energy and water consumption is reduced by
up to 1/4 when dishes are washed in the
upper basket only.
Water consumption values are based on a
water hardness setting of:
4 for Models DWF35 and DWF34
2 for Models DWF33 and DWF30
Switching the dishwasher ON.
- Press the mains switch to ON. The
indicator lights light up according to the
last selected programme.The same
programme will run again if no other
programme button is pressed.
- (Models DWF35 and DWF34 only)
The numerical display 7 shows the
expected duration of the programme.
The programme starts automatically.
- (Models DWF33 and DWF30 only)
The programme starts automatically.
End of Programme.
- (Models DWF35 and DWF34 only)
The programme has ended when a
figure 0 appears in the numerical
display 7 .
- (Models DWF33 and DWF30 only)
The programme has come to an end
when the Programme End indicator
10 light and the selected programme
indicator are both illuminated.
Switching the dishwasher OFF
Several minutes after the programme has
ended:
- Set the mains switch to OFF.
- Turn the water tap off.
- Remove dishes,etc.when they have
cooled down.
Interrupting the programme.
- Set the mains switch to OFF.
- The indicator light will go out.
The programme is retained in the
dishwashers memory.
- If the hot water was switched ON or
the appliance has already heated up
and then the appliance door opened,
leave the door ajar for several minutes
and then close.
Otherwise,the appliance door may fly
open due to expansion.
- In order to resume the stored
programme,set the mains switch to
ON again.
Note:
Plug-in delay timer cannot be used with
Models DWF33 and DWF30.
Washing Dishes
19
