Bedienungsanleitung Hotpoint EBL 20311 V (Seite 24 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

510837

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Installation

! Before placing your new appliance into operation please read

these operating instructions carefully. They contain important

information for safe use, for installation and for care of the

appliance.

! Please keep these operating instructions for future reference.

Pass them on to possible new owners of the appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free room.

2. Do not obstruct the rear fan grills. The compressor and

condenser give off heat and require good ventilation to operate

correctly and save energy.

3. Leave a space of at least 10 cm between the top part of the

appliance and any furniture above it, and at least 5 cm between

the sides and any furniture/side walls.

4. Ensure the appliance is away from any sources of heat (direct

sunlight, electric stove, etc.).

5. In order to maintain the correct distance between the appliance

and the wall behind it, fit the spacers supplied in the installation

kit, following the instructions provided.

Levelling

1. Install the appliance on a level and rigid floor.

2. If the floor is not perfectly horizontal, adjust the refrigerator by

tightening or loosening the front feet.

Electrical connections

After the appliance has been transported, carefully place it

vertically and wait at least 3 hours before connecting it to the

electricity mains. Before inserting the plug into the electrical socket

ensure the following:

• The appliance is earthed and the plug is compliant with the law.

• The socket can withstand the maximum power of the appliance,

which is indicated on the data plate located on the bottom left

side of the fridge (e.g. 150 W).

• The voltage must be in the range between the values indicated

on the data plate located on the bottom left side (e.g. 220-240V).

• The socket is compatible with the plug of the appliance. If the

socket is incompatible with the plug, ask an authorised

technician to replace it (see Assistance). Do not use extension

cords or multiple sockets.

! Once the appliance has been installed, the power supply cable

and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by authorised

technicians only (see Assistance).

The manufacturer declines any liability should these The manufacturer declines any liability should these

The manufacturer declines any liability should these

safety measures not be observed.safety measures not be observed.

safety measures not be observed.

Start-up and use

Starting the appliance

! Before starting the appliance, follow the installation

instructions (

see Installation

! Before connecting the appliance, clean the compartments and

accessories well with lukewarm water and bicarbonate.

! The appliance comes with a motor protection control system

which makes the compressor start approximately 8 minutes after

being switched on. The compressor also starts each time the

power supply is cut off whether voluntarily or involuntarily

(blackout).

1. Set the FREEZER OPERATION knob on

2. Insert the plug into the socket and ensure that the green

POWER indicator light illuminates.

3. Turn the REFRIGERATOR OPERATION knob to an average

value. After a few hours you will be able to put food in the

refrigerator.

4. Turn the FREEZER OPERATION knob to an average value and

press the SUPER FREEZE button (rapid freezing): the SUPER

FREEZE indicator light will illuminate. Once the refrigerator has

reached the optimal temperature, the indicator light goes out

and you can begin food storage.

Using the refrigerator to its full potential

• Place only cold or lukewarm foods in the compartment, never

hot foods (see Precautions and tips).

• Remember that cooked foods do not last longer than raw foods.

• Do not store liquids in open containers: they will increase the level

of humidity in the refrigerator and cause condensation to form.

SHELVES: with or without grill.

Due to the special guides the shelves are removable and the height

is adjustable , allowing easy storage of large containers and food.

Height can be adjusted without complete removal of the shelf.

TEMPERATURE Indicator light

*: to identify the coldest area in the

refrigerator.

1. Check that OK appears clearly on the indicator light (see

diagram).

2. If the word “OK” does not appear it means that the temperature is

too high: adjust the REFRIGERATOR OPERATION knob to a

higher position (colder) and wait approximately 10 hours until the

temperature has been stabilised.

3. Check the indicator light again: if necessary, readjust it following

the initial process. If large quantities of food have been added or

if the refrigerator door has been opened frequently, it is normal

for the indicator not to show OK. Wait at least 10 hours before

adjusting the REFRIGERATOR OPERATION knob to a higher

setting.

AIR *

It is recognizable due to the presence of the mechanism on the top

part of the refrigerator compartment (

see diagram

AIR maximises air circulation, improving the efficiency of the

evaporator and helping to achieve the optimal temperature inside

the refrigerator as quickly as possible each time it has been

opened. The blown air (A) is cooled when it comes into contact with

the cold wall, whereas the hotter air (B) is sucked up (

see

diagram

Using the freezer to its full potential

• Use the FREEZER OPERATION knob to adjust the temperature

(

see Description

Hotpoint EBL 20311 V Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info