Bedienungsanleitung Hotpoint HFO 3P23 WL - Ultima (Seite 6 von 8) (Englisch)

670822

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

LOADING THE RACKS

CUTLERY RACK

The third rack was designed to house the cutlery.

Arrange the cutlery as shown in the figure.

A separate arrangement of the cutlery makes collection easier after

washing and improves washing and drying performance.

Knives and other utensils with sharp edges must be positioned

with the blades facing downwards.

The geometry of the rack makes it possible to place such small items as

coffee cups in the area in the middle.

The cutlery basket is equipped

with two sliding side trays to

make the most of the height of

the space below and enable the

loading of high items into upper

rack.

UPPER RACK

Load delicate and light dishes:

glasses, cups, saucers, low salad

bowls.

(loading example for the upper rack)

ADJUSTING THE HEIGHT OF THE UPPER RACK

The height of the upper rack can be adjusted: high position to place

bulky crockery in the lower basket and low position to make the most

of the tip-up supports by creating more space upwards and avoid

collision with the items loaded into lower rack.

The upper rack is equipped with a Upper

Rack height adjuster (see figure), without

pressing the levers, lift it up by simply

holding the rack sides, as soon as the rack

is stable in its upper position.

To restore to the lower position, press the

levers A at the sides of the rack and move

the basket downwards.

We strongly recommend that you do

not adjust the height of the rack when it

is loaded.

NEVER raise or lower the basket on one side only.

FOLDABLE FLAPS WITH ADJUSTABLE POSITION

The side foldable flaps can be positioned at

three different heights to optimize the

arrangement of crockery inside the rack.

Wine glasses can be placed safely in the

foldable flaps by inserting the stem of each

glass into the corresponding slots.

For optimum drying results incline the

foldable flaps more. To change the

inclination, pull up the foldable flap, slide it

slightly and position it as you wish.

LOWER RACK

For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should

ideally be placed at the sides to avoid interferences with the spray arm.

The lower rack has tip-up supports which can be used in a vertical

position when arranging plates or in a horizontal position (lower) to

load pans and salad bowls easily.

The lower rack has a Space Zone (A), a special pull-out support in the

rear of the rack that can be used to support frying pans or baking pans

in upright position, thus taking up less space.

In order to use it, just get hold of the coloured grip and pull it upwards

(B) while rotating it forward. The supports can slide right and left to fit

the size of the crockery.

(loading example for the lower rack)

ZONE WASH 3D

Zone Wash 3D uses additional water jets

located both: in the lower and upper part of

the dishwasher (marked with orange color)

to wash more intensively heavily soiled

items by increasing water coverage on

dishes.

Example: Load pots and casseroles facing

lower part of Zone Wash 3D components

and activate the 3D Zone Wash option on

the panel.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hotpoint HFO 3P23 WL - Ultima Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info