Bedienungsanleitung Hozelock 7819 (Seite 5 von 48) (Alle Sprachen)

661753

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

physical, sensory or mental capabilities, or lack

of experience and knowledge, unless they

have been given supervision or instruction

concerning use of the appliance by a person

responsible for their safety

Before installation, and whenever you are

handling the pump, always disconnect from

the electrical supply.

To prevent injury, never put your fingers into the

mouth of the pump.

• Use the handle provided to carry or lift the

pump

• When used with a Water Butt for the first

time, ensure the water butt is emptied and

cleaned of all sediment, leaves and

accumulated debris.

Pump assembly :

Attach the metal baseplate to the pump with

the bolts and washers supplied

Screw one of the yellow accessory adaptors

to the inlet of the pump

Ensure seals are fitted to the front between

the pump and the adaptor

Ensure hand tight

Screw the filter onto the adaptor.

The arrow on the filter should point

towards the pump.

Ensure seal is fitted to the front between

the adaptor and the filter

Ensure hand tight

Remove filter adaptor from hose and attach

the suction hose to the filter

Ensure seal is fitted to the front between

the filter and the hose

Ensure all fittings are hand tight

Ensure that the inlet to the suction hose is at

least 150mm (6") under the surface of the

water. If required weight the end of the hose

using a brick.

It is critical that all the seals are present

and that all the joints are airtight.

There should be no elbows or kinks in the

suction hose as this will affect performance.

The installation should be consistant with

the limitations as shown in diagrams A & B

on the cover of this booklet.

Fill the pump chamber to the brim with tap

water using a watering can.

The Hozelock garden pumps are self

priming, therefore they can be primed

without filling the suction pipe or filter.

Attach the outlet connector to the outlet of

the pump.

Connect the garden hose to the outlet,

ensuring that the other end of the garden

hose is open and that it will be free to drain

when the pump is turned on.

Ensure that the suction hose is under the

surface of a suitable water reservoir (water

butt etc.).

Plug the pump into a suitable power supply.

When the power is turned on, the pump will

start the priming process. This operation can

take several minutes. During the priming

process the pump is pumping a mixture of air

and water, this drastically reduces the

performance of the pump and is very noisy.

The hose should be open ie. the other end

is not blocked or closed with either a spray

gun or waterstop connector

■ When the pump is primed and ready to use,

the noise reduces and the flow and pressure

are maximised.

If any of the seals or fittings are missing,

overtightened or loose the pump will not

prime.

If the pump does not prime after 5 minutes

- stop and repeat steps 6 to 10.

TO CONNECT TO AN IRRIGATION SYSTEM:

■ For use with hoses and hose reels

add a 2166 hose connector

(available separately) .

• The Hozelock Garden Pump has a built in

thermal protection switch. The pump stops if

an overload condition occurs. The motor

restarts automatically after it has cooled

down.

• Insert the plug into a 220-240v A/C socket.

Installation

Overload protection

To start the pump

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hozelock 7819 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info