ENWW 8-13
Media is not picked up from the front manual feed
l Check that the width guide is snug, but not tight, against the edge of
the paper.
l Make sure there is not more than 10 sheets of paper or three
transparencies loaded in the front manual feed.
l Make sure the media is not wrinkled or bent. Do not leave media in
the front manual feed overnight. Leaving media in the front manual
feed overnight can cause it to bend, especially if other media is also
in the tray.
l Check to make sure paper in Tray 1 is not interfering with the front
manual feed and causing more than one page to be fed. Remove
any media in Tray 1 and try again.
Media is not picked up from the rear manual feed
l The media you are using might be too thick. Try using a thinner
piece of paper to test whether the size of the media is the problem.
l The media might not be pushed in all the way. When you insert
media into the rear manual feed, the printer should pull the media in
after it is detected by the printer sensors.
Paper output problem
l If the output tray length guide is not extended for larger media,
output pages will fall off the printer. Make sure that output tray
length guide is extended.
l Remove excess media from the output tray. The output tray is not
designed to hold more than 60 sheets at a time.
Printing a diagnostic page
When you are experiencing a problem with your printer and you cannot
discover the source of the problem, you can print a diagnostic page that
supplies more information about the problem.
You can print a diagnostic page from the Toolbox if you have it
installed. Open the Toolbox, click Printer Services tab, and then click
Print a Diagnostic Page.
To print a diagnostic page from the LCD panel
1 Turn the printer on.
2 Press and hold down the POWER button. While holding down the
POWER button, press the CANCEL button one time.
EulerUG.book Page 13 Monday, July 16, 2001 5:34 PM
