Bedienungsanleitung HP LASERJET PRO CM1410 series (Seite 236 von 308) (Englisch)

584678

236

Zoom out

Zoom in

Vorherige Seite

1/308

Nächste Seite

Control panel message Description Recommended action

No fax detected. The product answered the incoming call but

did not detect that a fax machine was calling.

Allow the product to retry receiving the fax.

Open the Service menu, and touch the Fax

Service button. Touch the Run Fax Test

button. This test verifies that the phone cord

is connected to the correct port and that the

phone line has a signal. The product prints a

report with the results.

If the error persists, contact HP. See

www.hp.com/support/CM1410series or the

support flyer that came in the product box.

Print failure, press OK. If error repeats,

turn off then on.

The product could not print the current page

because of its complexity.

Touch the OK button to clear the message.

Replace [color] The print cartridge is at the end of its useful

life, and the At Very Low menu item in the

System Setup menu is set to Stop.

To ensure optimal print quality, HP

recommends replacing the print cartridge at

this point. You can continue printing until you

notice a decrease in print quality. Actual

cartridge life may vary.

Once an HP supply has reached “very low”,

HP's premium Protection Warranty on that

supply has ended. All print defects or

cartridge failures incurred when an HP supply

is used in continue at very low mode will not

be considered to be defects in materials or

workmanship in the supply under the HP Print

Cartridge Warranty Statement.

Scanner error #, Turn off then on The product has experienced an error in the

scanner sub-assembly area.

Turn off the power by using the power switch,

wait at least 30 seconds, and then turn on the

power and wait for the product to initialize.

Do not open the scanner lid until the

initialization process is complete.

If a surge protector is being used, remove it.

Plug the product directly into the wall socket.

Use the power switch to turn the product on.

If the error persists, contact HP. See

www.hp.com/support/CM1410series or the

support flyer that came in the product box.

Scanner reserved for PC scan A computer is using the product to create a

scan.

Wait until the computer scan has finished, or

cancel the scan from the computer software,

or touch the Cancel

button.

Scanning error Cannot connect The product cannot transmit scan information

to a computer.

Verify that the connection cable is not loose

or damaged. Replace the cable if necessary,

and try the scan again.

Settings cleared The product has cleared job settings. Re-enter any appropriate job settings.

Used [color] installed, to accept press OK A used color printer cartridge has been

installed or moved.

Touch the OK button to return to the Ready

state.

Yellow Cartridge Low The print cartridge is nearing the end of its

useful life.

Printing can continue, but consider having a

replacement supply on hand.

Table 13-1 Control-panel messages (continued)

220 Chapter 13 Solve problems ENWW

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP LASERJET PRO CM1410 series Seite 236

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von HP LASERJET PRO CM1410 series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info