Bedienungsanleitung HP OfficeJet Pro 8718 (Seite 135 von 171) (Englisch)

682181

135

Zoom out

Zoom in

Vorherige Seite

1/171

Nächste Seite

not hear a normal sounding dial tone, it might be a phone line set up for digital phones. Connect the

printer to an analog phone line and try sending or receiving a fax.

After you resolve any problems found, run the fax test again to make sure it passes and the printer is ready

for faxing. If the Dial Tone Detection test continues to fail, contact your telephone company and have them

check the phone line.

The "Fax Line Condition" test failed

● Make sure you connect the printer to an analog phone line or you cannot send or receive faxes. To check

if your phone line is digital, connect a regular analog phone to the line and listen for a dial tone. If you do

not hear a normal sounding dial tone, it might be a phone line set up for digital phones. Connect the

printer to an analog phone line and try sending or receiving a fax.

● Check the connection between the telephone wall jack and the printer to make sure the phone cord is

secure.

● Connect one end of the phone cord to your telephone wall jack, then connect the other end to the port

labeled 1-LINE on the back of the printer.

● Other equipment, which uses the same phone line as the printer, might be causing the test to fail. To nd

out if other equipment is causing a problem, disconnect everything from the phone line, and then run

the test again.

– If the Fax Line Condition Test passes without the other equipment, then one or more pieces of the

equipment is causing problems; try adding them back one at a time and rerunning the test each

time, until you identify which piece of equipment is causing the problem.

– If the Fax Line Condition Test fails without the other equipment, connect the printer to a working

phone line and continue reviewing the troubleshooting information in this section.

● If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord connector that

plugs into a telephone wall jack.) Try removing the splitter and connecting the printer directly to the

telephone wall jack.

After you resolve any problems found, run the fax test again to make sure it passes and the printer is ready

for faxing. If the Fax Line Condition test continues to fail and you experience problems faxing, contact your

telephone company and have them check the phone line.

Troubleshoot fax problems

Troubleshoot fax problems. Use an HP online troubleshooting wizard

Resolve problems sending or receiving a fax or faxing to your computer.

NOTE: The HP online troubleshooting wizards may not be available in all languages.

Read general instructions in the Help for specic fax problems

What kind of fax problem are you having?

The display always shows Phone O Hook

● HP recommends using a 2-wire phone cord.

● Other equipment that uses the same phone line as the printer might be in use. Make sure extension

phones (phones on the same phone line, but not connected to the printer) or other equipment are not in

ENWW Fax issues 125

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP OfficeJet Pro 8718 Seite 135

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von HP OfficeJet Pro 8718

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info