Bedienungsanleitung HP Pavilion - 550-104nd - Windows 8.1 (Seite 36 von 64) (Englisch)

617158

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Power cord set requirements

The power cord set received with the product meets the requirements for use in the country where

the equipment was originally purchased. Use only the power cord provided with the unit or an

authorized replacement power cord from Hewlett-Packard or an approved HP source. Replacement

part numbers may be found at http://www.hp.com/cgi-bin/hpsupport/index.pl.

Power cord sets for use in other countries must meet the requirements of the country where you use

the product. For more information on power cord set requirements, contact your authorized HP

dealer, reseller, or service provider.

WARNING! Do not use power cords from other products.

Mismatched power cords may result in a shock and fire hazard.

The requirements listed below are applicable to all countries:

1. The power cord must be approved by an acceptable accredited agency responsible for

evaluation in the country where the power cord set will be installed.

2. The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power

cord 2.0 m (6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm

18AWG. If the power cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a

minimum of 1.0 mm

or 16AWG.

The power cord should be routed so that it is not likely to be walked on or pinched by items placed

upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point

where the cord exits from the product.

WARNING! Do not operate this product with a damaged power cord set. If the power cord set is

damaged in any manner, replace it immediately. Damaged cords may result in user exposure to

hazards.

Japan power cord requirements

For use in Japan, use only the power cord received with this product.

CAUTION: Do not use the power cord received with this product on any other products.

Pinch hazard

WARNING! Observe pinch hazard areas. Keep fingers away from closing parts.

TV antenna connectors protection

External television antenna grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable

system is electrically grounded so as to provide some protection against voltage surges and built-up

static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with

regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in

wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit,

connection to grounding electrodes, and requirements for the grounding electrode.

28 Chapter 4 Safety notices for desktops, thin clients and personal workstations

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP Pavilion - 550-104nd - Windows 8.1 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von HP Pavilion - 550-104nd - Windows 8.1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info