Bedienungsanleitung HP Photosmart 3110 (Seite 98 von 166) (Englisch)

584737

Zoom out

Zoom in

Vorherige Seite

1/166

Nächste Seite

Receive a fax manually

If you set up your HP All-in-One to receive faxes manually (the Auto Answer option is

set to Off) or you answer the phone and hear fax tones, use the instructions in this

section to receive faxes.

1. Make sure the HP All-in-One is turned on and you have paper loaded in the main

tray.

2. If you are currently on the phone with the sender, instruct the sender to press

Start on their fax machine.

3. When you hear fax tones from a sending fax machine, do the following:

a. Press the Fax button on the control panel of your HP All-in-One.

b. Press

until Receive Fax Manually is highlighted, and then press OK.

c. Press Start Black or Start Color.

d. After the HP All-in-One begins to receive the fax, you can hang up the phone.

Tip If the phone you are using is on the same phone line as your HP All-

in-One, but is not plugged into the "2–EXT" port on the back of the HP All-

in-One, you might not be close enough to your HP All-in-One to reach the

control panel. If you cannot reach the control panel, wait several seconds,

and then press 1 2 3 on your phone.

If the HP All-in-One does not begin receiving the fax, wait several more

seconds and press 1 2 3 again. After the HP All-in-One begins to receive

the fax, you can hang up the phone.

Set up backup fax reception

Depending on your preference and security requirements, you can set up the HP All-

in-One to store all the faxes it receives, only the faxes it receives while the device is in

an error condition, or none of the faxes it receives.

Note The HP All-in-One deletes all the faxes stored in its memory when you

turn off the HP All-in-One. You can also delete the faxes from memory by

clearing the fax log from the Setup Menu, or changing the Backup Fax

Reception mode to Off. For more information, see the onscreen HP Image

Zone Help.

The following Backup Fax Reception modes are available: On, On Error Only, and

Off.

● On is the default setting. When Backup Fax Reception is On, the HP All-in-One

stores all faxes it receives in memory. This enables you to reprint up to eight of

the most recently printed faxes if they are still saved in memory. For more

information, see Reprint received faxes from memory.

Note After the memory becomes full, the HP All-in-One overwrites the

oldest, printed faxes as it receives new faxes. If the memory becomes full

of unprinted faxes, the HP All-in-One will stop answering incoming fax calls.

● On Error Only causes the HP All-in-One to store faxes in memory only if there is

an error condition that prevents the HP All-in-One from printing the faxes (for

example, if the HP All-in-One runs out of paper). The HP All-in-One will continue

to store incoming faxes as long as there is memory available. (If the memory

User Guide 95

Fax

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP Photosmart 3110 Seite 98

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von HP Photosmart 3110

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info