Bedienungsanleitung HP Pre 3 (Seite 227 von 234) (Englisch)

678998

227

Zoom out

Zoom in

Vorherige Seite

1/234

Nächste Seite

D : Regulatory and safety information 227

D Regulatory and safety information

This section contains the legal notices required by the regulatory bodies of your country.

United States (Product with FCC ID & FCC logo)

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference with one or more of the following measures:

• Reorient or relocate the receiving aerial.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this

device that are not expressly approved by HP may void the user’s authority to operate the

equipment.

The FCC has granted an Equipment Authorisation for this model device with all reported

SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR

information on this model device is on file with the FCC and can be found under the Display

Grant section of fcc.gov/oet/ea/fccid after searching for FCC ID B94HHF30CE.

Declaration of Conformity for Products Marked with the FCC Logo (United

States Only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause

undesired operation.

If you have questions about the product or this FCC declaration, write to:

Hewlett-Packard Company, 950 W. Maude Ave, Sunnyvale, Ca. 94085

For questions regarding this FCC declaration, call HP at 1-281-514-3333. For general

questions about the product, call 1-800-HP-INVENT (1-800-474-6836).

To identify your product, refer to the part, series or model number located on the product.

Cables

To maintain compliance with FCC Rules and Regulations, connections to this device must be

made with shielded cables having metallic RFI/EMI connector hoods.

WARNING! Exposure to Radio Frequency (RF) Radiation: The radiated output

power of this device is below the FCC radio frequency exposure limits.

Nevertheless, the device should be used in such a manner that the potential for

human contact during normal operation is minimised.

The exposure standard for wireless mobile device employs a unit of measurement known as

the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/Kg. Tests for

SAR are conducted using standard operating positions accepted by the FCC with the device

transmitting at its highest certified power level in all tested frequency bands. Although the

SAR is determined at the highest certified power level, the actual SAR level of the device

while operating can be well below the maximum value. This is because the device is

designed to operate at multiple power levels so as to use only the power required to reach

the network. In general, the closer you are to a wireless base station antenna, the lower the

power output. To avoid the possibility of exceeding the FCC radio frequency exposure limits,

human proximity to the antenna should be minimised. No metallic body accessories are

allowed and a 1.5 cm space between this device and the body must be maintained to

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HP Pre 3 Seite 227

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von HP Pre 3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info